Test 2020-04-15-3-7 (AASHTO T324-14) Summary

Project Information
Project IdentifiersProject ID: 214587
DEA: 101J1604
EFIS: 1018000180
DIST-CO-RTE-PM10-STA-132-27.9/41.0
Work DescriptionCOLD PLANE AC PAVEMENT, RHMA OVERLAY AND SLURRY SEAL.
Location DescriptionSTANISLAUS COUNTY IN AND NEAR WATERFORD FROM G STREET TO 1.2 MILES EAST OF RUSHING ROAD
Sample Information
Sample Taken Date4/15/2020 Sample Unique Key3
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing4/15/2020
Sample typeVerification A brief description of the sampleType A HMA with RAP
The quantity of what the sample constitutes16 boxes of 3/4" Type A HMA with RAP From where was the sample collectedSource
First name of sampler or witnessed byJ Last name of sampler or witnessed byKort
Title of samplerTechnician Laboratory sample identification
The fabricator/manufacturer/facility nameGeorge Reed Inc Transportation Laboratory (TL) NumberC033878
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name
Material Information
Material TypeHot Mix Asphalt HMA TypeType A HMA
HMA Grading3/4 inch Lot numberUnknown
Sublot numberUnknown JMF Verification ID JMF3513-2020-109
Test Details
DIME Sample ID: 2020-04-15-3
DIME Test ID: 2020-04-15-3-7
Testing Lab: CT HQ - Hot Mix Asphalt Laboratory
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2020-05-01
Test Results

Input Type: Calculated
Tester's full name: Frank Chavez Jr
Date of test: 04/17/2020
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average:no data
Impression at specified number of passes average:no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A):15000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B):15000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A):3.65 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B):2.2 mm
Stripping Inflection Point (Wheel A):>10000
Stripping Inflection Point (Wheel B):>10000
General comments (publicly viewable) (Max 1000 characters):

Test was verified on 05/01/2020