DIME - Test Summary

Summary for Test 2019-12-03-7-1

Test performed: CTM 202-November 2011

Project Identifiers	Project ID: 213261 DEA: 071XH004 EFIS: 0718000239
DIST-CO-RTE-PM	07-LA-47-.86, 0.86, 0.86
Award Date	03/20/2018
Closeout Date	06/03/2020
Work Description	Remove and replace the two (2) long finger joint assemblies at Bents 11 and 12 and repair the elevators in both towers
Location Description	Not set
QA Service Level	1 (Verified on 06/08/2018)

Sample Taken Date	12/03/2019	Sample Unique Key	7
Will the laboratory/organization for which you are a member perform testing on this material sample?	Yes	Date that the sample was received by the laboratory/organization performing the testing	12/05/2019
Sample type	Acceptance	A brief description of the sample	Washed Concrete Sand
The quantity of what the sample constitutes	1 bag	From where was the sample collected	Distributor
First name of sampler or witnessed by	TUAN	Last name of sampler or witnessed by	NGUYEN
Title of sampler	MREA	Telephone number of sampler
Laboratory sample identification	8954	Linked DIME Sample ID	2019-12-03-7
The fabricator/manufacturer/facility name	GEORGE TAROOP PASADENA	Transportation Laboratory (TL) Number	C912526
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	Unknown
The fabricator's/manufacturer's product name for the sample	Unknown	The fabricator/manufacturer designation for the sample	Unknown
The plant number	Unknown	A detailed description of where the material sample was collected	unknown
Where the material sample would have been placed if not sampled	Unknown	Primary Aggregate Nominal Size	fine
The concrete mix design number	Unknown	Lot number	Unknown
Sublot number	Unknown	Aggregate Mix Number	Not set

DIME Sample ID: 2019-12-03-7

DIME Test ID: 2019-12-03-7-1

Testing Lab: CT D08 - Fontana Southern Regional Laboratory

Test Method: CTM 202-November 2011: Method of Test for Sieve Analysis of Fine and Coarse Aggregates

Test Release Date: 2020-03-17

What size aggregate is being tested?: Fine Aggregate

Individual or cumulative mass retained on each sieve?: Cumulative Mass Retained

For Combined Gradation only, has the fine aggregate sample been reduced?: No

For Combined Gradation only, use #40 Sieve?: No

Input Type: Calculated

Tester's full name: SATISH JAIM

Date of test: 12/10/2019

Cumulative percent passing the 3/8 in. sieve: 100 %

Cumulative percent passing the #4 sieve: 96 %

Cumulative percent passing the #8 sieve: 84 %

Cumulative percent passing the #16 sieve: 70 %

Cumulative percent passing the #30 sieve: 49 %

Cumulative percent passing the #50 sieve: 21 %

Cumulative percent passing the #100 sieve: 7 %

Cumulative percent passing the #200 sieve: 2.9 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 3/17/2020 ✔