Summary for Test 2019-04-15-3-7
Test performed: ASTM D4791-10Project Information
Project Identifiers | Project ID: 213255 DEA: 081E5814 EFIS: 0816000072 |
---|---|
DIST-CO-RTE-PM | 08-SBD-95-40.0/40.4 |
Award Date | 06/04/2018 |
Closeout Date | 09/30/2019 |
Work Description | WIDEN SHOULDERS AND PLACE GROUND-IN RUMBLE STRIP |
Location Description | SAN BERNARDINO COUNTY NEAR NEEDLES FROM 2.7 MILES TO 3.1 MILES NORTH OF HAVASU LAKE ROAD |
QA Service Level | 1 (Verified on 01/07/2019) |
Sample Information
Sample Taken Date | 04/15/2019 | Sample Unique Key | 3 |
---|---|---|---|
Will the laboratory/organization for which you are a member perform testing on this material sample? | Yes | Date that the sample was received by the laboratory/organization performing the testing | 04/16/2019 |
Sample type | Verification | A brief description of the sample | 3/4 HMA-A-SP |
The quantity of what the sample constitutes | JMF 12 bags | From where was the sample collected | Manufacturer |
First name of sampler or witnessed by | Larry | Last name of sampler or witnessed by | Fransisco |
Title of sampler | Telephone number of sampler | ||
Laboratory sample identification | 0229A-19 | Linked DIME Sample ID | |
The fabricator/manufacturer/facility name | West Coast Aggregate | Transportation Laboratory (TL) Number | |
Inspector Lot Number from the Transportation Laboratory (TL) Form | Structure unique identifier | Not set | |
Structure name | Not set |
Material Information
Material Type | Aggregate | Source Identification (SMARA, name of Pit or Job Site) | 91-33-0072 |
---|---|---|---|
The fabricator's/manufacturer's product name for the sample | 3/4 HMA-A-SP | The fabricator/manufacturer designation for the sample | 3881 |
The plant number | Unknown | A detailed description of where the material sample was collected | Belt Cut at Plant |
Where the material sample would have been placed if not sampled | Unknown | Primary Aggregate Nominal Size | 3/4 inch |
The concrete mix design number | Unknown | Lot number | Unknown |
Sublot number | Unknown | Aggregate Mix Number | Not set |
Test Details
DIME Sample ID: 2019-04-15-3
DIME Test ID: 2019-04-15-3-7
Testing Lab: CT D08 - Fontana Southern Regional Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2019-04-30
Test Results
Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles
Method: B
Determination: By Mass
Dimensional ratio used: 1:5
Input Type: Calculated
Tester's full name: Satish Jain
Date of test: 04/19/2019
Weighted percentage of particles (by mass) that were flat and elongated: 1 %
Weighted percentage of particles (by mass) that were not flat and elongated: 99 %
General comments (publicly viewable) (Max 1000 characters):
Test was verified on 4/23/2019 ✔