DIME - Test Summary

Summary for Test 2021-10-10-1-1

Test performed: ASTM C117-17

Project Identifiers	Project ID: 209820 DEA: 04297634 EFIS: 0415000040 COOP: 042548
DIST-CO-RTE-PM	04-ALA-84,680-17.9/21
Award Date	02/19/2021
Closeout Date	Not set
Work Description	ROUTE 84 WIDENING (4-LANE EXPRESSWAY) FROM I-680 TO PIGEON PASS, INCLUDING INTERSECTION, DRAINAGE IMPROVEMENTS AND UTILITY RELOCATION.
Location Description	ALAMEDA COUNTY IN AND NEAR SUNOL, PLEASANTON, AND LIVERMORE ON ROUTE 84 FROM 0.1 MILE EAST OF ROUTE 680 TO 0.1 MILE SOUTH OF RUBY HILL DRIVE AND ON ROUTE 680 FROM 1.2 MILES SOUTH TO 1.8 MILES NORTH OF ROUTE 84
QA Service Level	1 (Verified on 11/04/2019)

Sample Taken Date	10/10/2021	Sample Unique Key	1
Will the laboratory/organization for which you are a member perform testing on this material sample?	No	Date that the sample was received by the laboratory/organization performing the testing	10/10/2021
Sample type	Quality Control	A brief description of the sample	sand
The quantity of what the sample constitutes	weeks production	From where was the sample collected	Manufacturer
First name of sampler or witnessed by	Mike	Last name of sampler or witnessed by	Kocunik
Title of sampler	Lab Manager	Telephone number of sampler
Laboratory sample identification		Linked DIME Sample ID
The fabricator/manufacturer/facility name	Teichert	Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form		Structure unique identifier
Structure name

Material Type	Aggregate	Source Identification (SMARA, name of Pit or Job Site)	91-34-0045::ASPEN IV SOUTH
The fabricator's/manufacturer's product name for the sample		The fabricator/manufacturer designation for the sample
The plant number		A detailed description of where the material sample was collected	stockpile
Where the material sample would have been placed if not sampled		Primary Aggregate Nominal Size	fine
The concrete mix design number		Lot number
Sublot number		Aggregate Mix Number	Not set

DIME Sample ID: 2021-10-10-1

DIME Test ID: 2021-10-10-1-1

Testing Lab: Rinker Materials

Test Method: ASTM C117-17: Standard Test Method for Materials Finer than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing

Test Release Date: 2021-10-20

Input Type: Calculated

Tester's full name: Joe Buckley

Date of test: 10/10/2021

The method used?: Procedure A

Percent finer than No. 200 sieve: 2.7 %

General comments (publicly viewable) (Max 1000 characters):

Test was verified on 10/20/2021 ✔