Test 2021-06-02-15-6 (AASHTO T324-14) Summary

Project Information
Project IdentifiersProject ID: 215245
DEA: 021J4504
EFIS: 0220000080
DIST-CO-RTE-PM02-SIS-89-14.0/19.0
Work DescriptionPLACE HMA (TYPE A).
Location DescriptionSISKIYOU COUNTY ABOUT 6 MILES NORTH OF BARTLE FROM 0.4 MILE NORTH OF EDISON CREEK ACCESS ROAD TO 2.0 MILES SOUTH OF MUD CREEK BRIDGE
Sample Information
Sample Taken Date6/2/2021 Sample Unique Key15
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing6/2/2021
Sample typeAcceptance A brief description of the sample3/8 Type A HMA 25 RAP PG 58 34m Valero Benecia
The quantity of what the sample constitutesPSE 16 boxs From where was the sample collectedManufacturer
First name of sampler or witnessed byRandy Last name of sampler or witnessed by.
Title of samplerCGI Laboratory sample identificationD78818
The fabricator/manufacturer/facility nameJF Shea Construction, Fawndale Rock and Asphalt, Redding, CA Transportation Laboratory (TL) Number858981
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name
Material Information
Material TypeHot Mix Asphalt HMA TypeType A HMA
HMA Grading3/8 inch Lot numberUnknown
Sublot numberUnknown HMA Design ID
Test Details
DIME Sample ID: 2021-06-02-15
DIME Test ID: 2021-06-02-15-6
Testing Lab: CT D02 - North Region Materials Lab
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Test Release Date: 2021-08-20
Test Results

Input Type: Measured
Tester's full name: Dennis Hickey
Date of test: 06/07/2021
HMA Production: Field Plant Produced
Specified number of passes at 12.7 mm: 15000
Specified number of passes at inflection point: no data
Type and Amount of Anti-Stripping Additive: 1.2% Lime
Compaction Method: SGC Cylindrical Specimen
Test Temperature: 122 F
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 2.6 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 2.5 mm
Stripping Inflection Point (Wheel A): >25000
Stripping Inflection Point (Wheel B): >25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth average:25000
Impression at specified number of passes average:3 mm
General comments (publicly viewable) (Max 1000 characters): CT 389 required by special provision. Air voids in SGC specimens used were 7 ± 1.

Test was verified on 08/20/2021