Summary for Test 2021-04-19-40-6

Test performed: ASTM D4791-10

Project Information

Project IdentifiersProject ID: 215179
DEA: 010F4704
EFIS: 0116000011
DIST-CO-RTE-PM01-HUM-299-30.7/37.7
Award Date11/19/2020
Closeout Date11/27/2023
Work DescriptionPLACE HMA & RHMA-G & CONSTRUCT SOLDIER PILE WALL.
Location DescriptionHUMBOLDT COUNTY NEAR WILLOW CREEK AT VARIOUS LOCATIONS FROM 0.1 MILE EAST OF CEDAR CREEK ROAD TO 1.1 MILES WEST OF ROUTE 96 JUNCTION
QA Service Level1 (Verified on 09/15/2020)

Sample Information

Sample Taken Date04/19/2021 Sample Unique Key40
Will the laboratory/organization for which you are a member perform testing on this material sample?Yes Date that the sample was received by the laboratory/organization performing the testing06/08/2021
Sample typeDispute Resolution A brief description of the sample3/4" HMA PG64-16 NO RAP
The quantity of what the sample constitutes2 bags From where was the sample collectedManufacturer
First name of sampler or witnessed byna Last name of sampler or witnessed byna
Title of sampler Telephone number of sampler
Laboratory sample identification21-JMFDP-0110 Linked DIME Sample ID
The fabricator/manufacturer/facility nameMercer Fraser - Willow Creek Transportation Laboratory (TL) Number
Inspector Lot Number from the Transportation Laboratory (TL) Form Structure unique identifier
Structure name

Material Information

Material TypeAggregate Source Identification (SMARA, name of Pit or Job Site)91-12-0007
The fabricator's/manufacturer's product name for the sample The fabricator/manufacturer designation for the sample
The plant number A detailed description of where the material sample was collectedPlant
Where the material sample would have been placed if not sampled Primary Aggregate Nominal Size3/4 inch
The concrete mix design number Lot number
Sublot number Aggregate Mix NumberNot set

Test Details

DIME Sample ID: 2021-04-19-40
DIME Test ID: 2021-04-19-40-6
Testing Lab: CT HQ - Sacramento Aggregate Testing Laboratory
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Test Release Date: 2021-06-18

Test Results


Method A - Percentage of Flat Particles, Elongated Particles, and Flat & Elongated Particles
Method B - Flat & Elongated Particles

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Input Type: Calculated
Tester's full name: Jay Horton
Date of test: 06/17/2021
Weighted percentage of particles (by mass) that were flat and elongated: 0 %
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %
General comments (publicly viewable) (Max 1000 characters): % by mass at 5:1

Test was verified on 6/18/2021