Print Report | Back to Test Summary

Testing Report for 2020-11-12-6-6

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: JMFPP
EFIS: 0019000043
Project ID: 66667
QA Service Level:
DIST-CO-RTE-PM: 59---
Work Description: Special project for submitting Sample information for JMF Prequalification Program.
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2020-11-12-6
TL Number from the TL Form:
Sample Submitted By Organization: Syar Industries, Inc.
Sample Organization Contact: 707-259-5705
Type of Sample: Preliminary
Type of Material: Hot Mix Asphalt
Sample Taken Date: 11/12/2020
Date that the sample was received by the laboratory/organization performing the testing: 11/12/2020
The quantity of what the sample constitutes: 780 Pound
A brief description of the sample: 3/4" HMA-SP RAP WMA
From where was the sample collected: Manufacturer
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Syar Lake Herman Batch

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2020-11-12-6-6
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Date Tested: 11/12/2020
Verified Date: 11/17/2020
Submitted By Organization: Syar Industries, Inc.
Organization Address: 2301 Napa-Vallejo Hwy,P.O. Box 2540
Organization City: Napa
Organization State: CA
Organization Zipcode: 94558
Organization Email: mherlax@syar.com
Organization Phone: 707-259-5705
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): no data
Stripping Inflection Point (Wheel A): no data
Stripping Inflection Point (Wheel B): no data