Print Report | Back to Test Summary

Testing Report for 2020-08-06-44-7

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 07301504
EFIS: 0714000020
Project ID: 213603
QA Service Level: 1
DIST-CO-RTE-PM: 07-LA-1,10-R34.6/35.2,R2.1/18.4
Work Description: REPLACING CONCRETE AND AC PAVEMENT
Location Description: LOS ANGELES COUNTY IN SANTA MONICA AND LOS ANGELES ON ROUTE 1 FROM 0.1 MILE WEST OF MAIN STREET OVERCROSSING TO ROUTE 1/10 SEPARATION AND ON ROUTE 10 FROM ROUTE 1/10 SEPARATION TO ROUTE 5/10 SEPARATION AND AT ROUTE 10/110 SEPARATION
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Mahinda Ram
Structure Rep.: Frank Lotfi

Sample Information

DIME Sample ID: 2020-08-06-44
TL Number from the TL Form:
Sample Submitted By Organization: CT - Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 8/6/2020
Date that the sample was received by the laboratory/organization performing the testing: 8/20/2020
The quantity of what the sample constitutes: 3 Bags Of Coldfeed Agg., 2 Bags Of rap
A brief description of the sample: JMF 1/2" HMA-A-SP r15 0.5% LAS
From where was the sample collected: Manufacturer
Laboratory sample identification: 0514A-20
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Vulcan Materials-Irwindale

Material Information

Source Identification (SMARA or name of Pit): 91-19-0035
The fabricator's/manufacturer's product name for the sample: 1/2 HMA-A-SP R15
The fabricator/manufacturer designation for the sample:
The plant number: 320819A IRW LTR
A detailed description of where the material sample was collected: Belt Cut at Vulcan Materials-Irwindale
Where the material sample would have been placed if not sampled: Asphalt Paving
Primary Aggregate Nominal Size: 1/2 inch
The concrete mix design number:
Lot number:
Sublot number:

Test Information

DIME Test ID: 2020-08-06-44-7
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Date Tested: 8/28/2020
Verified Date: 8/31/2020
Submitted By Organization: CT - Southern Regional Laboratory
Organization Address: 13970 Victoria St,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email: jose.guzman@dot.ca.gov
Organization Phone: 213-792-4794
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Method: B
Determination: By Mass
Dimensional ratio used: 5:1
Weighted percentage of particles (by mass) that were flat and elongated: no data
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %