Print Report | Back to Test Summary

Testing Report for 2020-07-01-24-6

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 080M9004
EFIS: 0812000248
Project ID: 214924
QA Service Level: 2
DIST-CO-RTE-PM: 08-RIV-111-18.0/19.0
Work Description: The purpose of the project is to provide a grade separated crossing over the existing UPRR, SR-111 and Hammond Road in the Mecca Community that will provide the following benefits: provide a secondary access point to the Community of Mecca.
Location Description: The project is in Riverside County from 0.47 miles east of State Route 86 to 0.45 miles west of Johnson Street.
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Francisco Montellano
Structure Rep.: Shukri Abouazra

Sample Information

DIME Sample ID: 2020-07-01-24
TL Number from the TL Form:
Sample Submitted By Organization: CT - Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 7/1/2020
Date that the sample was received by the laboratory/organization performing the testing: 7/13/2020
The quantity of what the sample constitutes: 3 Bags Combined Aggregate
A brief description of the sample: JMF 3/4" RHMA-G-SP 0.50% LAS Aggregate
From where was the sample collected: Manufacturer
Laboratory sample identification: 0429G-20
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Matich-Cabazon

Material Information

Source Identification (SMARA or name of Pit): 91-33-0008, 91-36-0040
The fabricator's/manufacturer's product name for the sample: 3/4 RHMA-G-SP
The fabricator/manufacturer designation for the sample:
The plant number: CHP 68E
A detailed description of where the material sample was collected: Belt Cut at Matich Cabazon Plant
Where the material sample would have been placed if not sampled: Asphalt Paving
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number:
Lot number:
Sublot number:

Test Information

DIME Test ID: 2020-07-01-24-6
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Date Tested: 7/15/2020
Verified Date: 7/21/2020
Submitted By Organization: CT - Southern Regional Laboratory
Organization Address: 13970 Victoria St,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email: jose.guzman@dot.ca.gov
Organization Phone: 213-792-4794
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Sand Equivalent: 85