Print Report | Back to Test Summary

Testing Report for 2019-03-30-1-7

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 080J6104
EFIS: 0800000308
Project ID: 212466
QA Service Level: 2
DIST-CO-RTE-PM: 08--15-36.4/37.6
Work Description: Enter onto Interstate 15 right of way at Cajalco Road to reconstruct the interchange by replacing the existing 2-lane overcrossing bridge with a new six-lane bridge, reconfigure the NB ramps into a partial cloverleaf, and to relocate the SB ramps further to the west, as per permit Plans and Special
Location Description: I-15 /Cajalco Rd Interchange, Corona
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Arfan Haidary
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2019-03-30-1
TL Number from the TL Form:
Sample Submitted By Organization: CT - Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 3/30/2019
Date that the sample was received by the laboratory/organization performing the testing: 4/11/2019
The quantity of what the sample constitutes: JMF 8 bags
A brief description of the sample: 3/4 HMA-A-SP
From where was the sample collected: Manufacturer
Laboratory sample identification: 0224A-19
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: All American Asphalt Corona

Material Information

Source Identification (SMARA or name of Pit): 91-33-0005::ALL AMERICAN ASPHALT
The fabricator's/manufacturer's product name for the sample: 3/4 HMA-A-SP
The fabricator/manufacturer designation for the sample: 106927
The plant number: Unknown
A detailed description of where the material sample was collected: Manufacturer
Where the material sample would have been placed if not sampled: Unknown
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number: Unknown
Lot number: Unknown
Sublot number: Unknown

Test Information

DIME Test ID: 2019-03-30-1-7
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Date Tested: 4/16/2019
Verified Date: 4/23/2019
Submitted By Organization: CT - Southern Regional Laboratory
Organization Address: 13970 Victoria St,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email:
Organization Phone: 213-792-4794
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Method: B
Determination: By Mass
Dimensional ratio used: 1:5
Weighted percentage of particles (by mass) that were flat and elongated: no data
Weighted percentage of particles (by mass) that were not flat and elongated: 100 %