Print Report | Back to Test Summary

Testing Report for 2018-05-15-39-6

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 023E7204
EFIS: 0200020154
Project ID: 212679
QA Service Level: 1
DIST-CO-RTE-PM: 02-TEH-36-42.1/46.0
Work Description: COLD PLANING, PAVING, MINOR CONCRETE, ELECTRICAL AND STRIPING WORK.
Location Description: TEHAMA COUNTY IN AND NEAR RED BLUFF FROM EAST SAND SLOUGH BRIDGE TO 0.6 MILE EAST OF STICE ROAD
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Anthony Granados
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2018-05-15-39
TL Number from the TL Form: 847541
Sample Submitted By Organization: CT D02 - North Region Materials Lab
Sample Organization Contact: (530) 225-3194
Type of Sample: Verification
Type of Material: Hot Mix Asphalt
Sample Taken Date: 5/15/2018
Date that the sample was received by the laboratory/organization performing the testing: 5/15/2018
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: 3/4-inch RHMA-G, PG 64-16 CR with Zycosoil
From where was the sample collected: Manufacturer
Laboratory sample identification: D77385
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Tullis, Inc - Northstate Asphalt - Redding, CA

Material Information

HMA Type: RHMA-G
HMA Grading: 3/4 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2018-05-15-39-6
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Date Tested: 5/22/2018
Verified Date: 8/14/2018
Submitted By Organization: CT D02 - North Region Materials Lab
Organization Address: 1657 Riverside Dr,MS-83
Organization City: Redding
Organization State: CA
Organization Zipcode: 96001
Organization Email: ward.jenkins@dot.ca.gov
Organization Phone: (530) 225-3194
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): no data
Stripping Inflection Point (Wheel A): >25000
Stripping Inflection Point (Wheel B): no data