Print Report | Back to Test Summary

Testing Report for 2017-01-10-4-1

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 59912684
Project ID: 8196
QA Service Level: 1
Work Description:
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2017-01-10-4
TL Number from the TL Form: NA
Sample Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Sample Organization Contact: (916) 227-7253
Type of Sample: Quality Assurance
Type of Material: SMTL TM2 - Type B Elastomeric Joint Seal
Sample Taken Date: 1/10/2017
Date that the sample was received by the laboratory/organization performing the testing: 1/11/2017
The quantity of what the sample constitutes: 500ft
A brief description of the sample: Joint Seal
From where was the sample collected: Manufacturer
Laboratory sample identification: Unknown
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Watson Bowman

Material Information

Mfg. Lot Number(s): 0116449
Manufacturer(s): Watson Bowman
Temperature: 72
Humidity: 50
Comments: Unknown
Joint Seal Size: 1.75"

Test Information

DIME Test ID: 2017-01-10-4-1
Test Method: CTM 673-July 2012: Method of Determining Movement Rating of Type B1 and B2 Preformed Elastomeric Joint Seals
Date Tested: 1/13/2017
Verified Date: 1/24/2017
Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email:
Organization Phone: (916) 227-7253
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Temperature: 72 ?F
Humidity: 50 %
Load at W1: 53.0167 lbs
Width at 4 x Load at W1: 0.877569 in
Nominal Width: 1.75 in
Measured Maximum Uncompressed Width: 1.949 in
Measured Minimum Uncompressed Width: 1.8945 in
Minimum Uncompressed Width as Specified by the Manufacturer (MUWASBM): 1.85 in
Height of Contact Face: 1.9 in
Spec Minimum Uncompressed Width: 1.85 in
Area (5 Times of the Height of Contact Face): 9.5 sqin
Half of the Spec Minimum Uncompressed Width: 0.925 in
85 Percent of the Spec Minimum Uncompressed Width: 1.5725 in
3 Times of the Area: 28.5 sqin
4 Times of the Load at W1: 212.067 in
W1 (US Units): 1.573 in
W1 (Metric Units): 39.942 millimeters
W2 (US Units): 0.878 in
W2 (Metric Units): 22.29 millimeters
Satisfactory of MR of (US Units): 0.695 in
Satisfactory of MR of (Metric Units): 17.651 millimeters
Optional W1 Measurement 1: 1.6103 in
Optional W1 Measurement 2: 28.69 sqin