Print Report | Back to Test Summary

Testing Report for 2016-06-21-6-1

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 59912684
EFIS:
Project ID: 8196
QA Service Level: 1
DIST-CO-RTE-PM: 59---
Work Description:
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2016-06-21-6
TL Number from the TL Form: Unknown
Sample Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Sample Organization Contact: (916) 227-7253
Type of Sample: Quality Assurance
Type of Material: SMTL TM2 - Type B Elastomeric Joint Seal
Sample Taken Date: 6/21/2016
Date that the sample was received by the laboratory/organization performing the testing: 6/23/2016
The quantity of what the sample constitutes: 45ft
A brief description of the sample: Joint Seal
From where was the sample collected: Source
Laboratory sample identification: Unknown
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Watson Bowman

Material Information

Mfg. Lot Number(s): 0216265
Manufacturer(s): Watson Bowman
Temperature: 72
Humidity: 50
Comments: Unknown
Joint Seal Size: 6.00

Test Information

DIME Test ID: 2016-06-21-6-1
Test Method: CTM 673-July 2012: Method of Determining Movement Rating of Type B1 and B2 Preformed Elastomeric Joint Seals
Date Tested: 6/24/2016
Verified Date: 7/11/2016
Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: paul.lukkarila@dot.ca.gov
Organization Phone: (916) 227-7253
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

UTM: 2KIP
Temperature: no data
Humidity: 50 %
Load at W1: 91.0042 lbs
Width at 4 x Load at W1: 2.74511 in
Nominal Width: 6 in
Measured Maximum Uncompressed Width: 6.447 in
Measured Minimum Uncompressed Width: 6.2175 in
Minimum Uncompressed Width as Specified by the Manufacturer (MUWASBM): 6.23 in
Height of Contact Face: no data
Spec Minimum Uncompressed Width: 6.2175 in
Area (5 Times of the Height of Contact Face): no data
Half of the Spec Minimum Uncompressed Width: 3.115 in
85 Percent of the Spec Minimum Uncompressed Width: 5.28487 in
3 Times of the Area: no data
4 Times of the Load at W1: 364.017 in
W1 (US Units): 5.285 in
W1 (Metric Units): 134.236 millimeters
W2 (US Units): 2.745 in
W2 (Metric Units): 69.726 millimeters
Satisfactory of MR of (US Units): 2.54 in
Satisfactory of MR of (Metric Units): 64.51 millimeters
Optional W1 Measurement 1: 5.2849 in
Optional W1 Measurement 2: no data