Print Report | Back to Test Summary

Testing Report for 2016-04-06-8-1

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 59912684
EFIS:
Project ID: 8196
QA Service Level: 1
DIST-CO-RTE-PM: 59---
Work Description:
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2016-04-06-8
TL Number from the TL Form: Unknown
Sample Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Sample Organization Contact: (916) 227-7253
Type of Sample: Quality Assurance
Type of Material: SMTL TM2 - Type B Elastomeric Joint Seal
Sample Taken Date: 4/6/2016
Date that the sample was received by the laboratory/organization performing the testing: 4/7/2016
The quantity of what the sample constitutes: 550ft
A brief description of the sample: Joint Seal
From where was the sample collected: Source
Laboratory sample identification: Unknown
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Watson Bowman

Material Information

Mfg. Lot Number(s): 0616190
Manufacturer(s): Watson Bowman
Temperature: 72
Humidity: 50
Comments: Unknown
Joint Seal Size: 3.75in

Test Information

DIME Test ID: 2016-04-06-8-1
Test Method: CTM 673-July 2012: Method of Determining Movement Rating of Type B1 and B2 Preformed Elastomeric Joint Seals
Date Tested: 4/11/2016
Verified Date: 4/20/2016
Submitted By Organization: CT HQ - Sacramento Structural Materials Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: paul.lukkarila@dot.ca.gov
Organization Phone: (916) 227-7253
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified :

Submitted Test Results

UTM: 2KIP
Temperature: 72 ?F
Humidity: 50 %
Load at W1: 54.21 lbs
Width at 4 x Load at W1: 1.53268 in
Nominal Width: 3.75 in
Measured Maximum Uncompressed Width: 3.9195 in
Measured Minimum Uncompressed Width: 3.8325 in
Minimum Uncompressed Width as Specified by the Manufacturer (MUWASBM): 3.88 in
Height of Contact Face: no data
Spec Minimum Uncompressed Width: 3.8325 in
Area (5 Times of the Height of Contact Face): no data
Half of the Spec Minimum Uncompressed Width: 1.94 in
85 Percent of the Spec Minimum Uncompressed Width: 3.25763 in
3 Times of the Area: no data
4 Times of the Load at W1: 216.84 in
W1 (US Units): 3.258 in
W1 (Metric Units): 82.744 millimeters
W2 (US Units): 1.533 in
W2 (Metric Units): 38.93 millimeters
Satisfactory of MR of (US Units): 1.725 in
Satisfactory of MR of (Metric Units): 43.814 millimeters
Optional W1 Measurement 1: 3.2576 in
Optional W1 Measurement 2: no data