Print Report | Back to Test Summary

Testing Report for 2021-08-04-35-1

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: JMFPP
EFIS: 0019000043
Project ID: 66667
QA Service Level:
DIST-CO-RTE-PM: 59---
Work Description: Special project for submitting Sample information for JMF Prequalification Program.
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2021-08-04-35
TL Number from the TL Form:
Sample Submitted By Organization: RMA Group
Sample Organization Contact: (909) 989-1751
Type of Sample: Informational
Type of Material: Hot Mix Asphalt
Sample Taken Date: 8/4/2021
Date that the sample was received by the laboratory/organization performing the testing: 8/4/2021
The quantity of what the sample constitutes: 12 Boxes
A brief description of the sample: RHMA
From where was the sample collected: Supplier
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: AAA Corona

Material Information

HMA Type: RHMA-G
HMA Grading: 1/2 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2021-08-04-35-1
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Date Tested: 8/4/2021
Verified Date: 9/1/2021
Submitted By Organization: RMA Group
Organization Address: 12130 Santa Margarita Court,
Organization City: Rancho Cucamonga
Organization State: CA
Organization Zipcode: 91730
Organization Email: cbachler@rmacompanies.com
Organization Phone: (909) 989-1751
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 15000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 15000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 3 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 5 mm
Stripping Inflection Point (Wheel A): >25000
Stripping Inflection Point (Wheel B): >25000