Print Report | Back to Test Summary

Testing Report for 2021-02-16-37-7

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 214515 DEA: 024F6004 EFIS: 0213000012 QA Service Level: 1
DIST-CO-RTE-PM: 02-SIS,TRI-36,96,299-VAR
Work Description: BRIDGE DECK REPAIR, POLYESTER OVERLAY AND RAIL REPLACEMENT.
Location Description: SISKIYOU AND TRINITY COUNTIES AT VARIOUS LOCATIONS
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Sunil Repaka Structure Rep.: Robert Thompson

Sample Information

DIME Sample ID: 2021-02-16-37
TL Number from the TL Form: 853474
Sample Submitted By Organization: CT D02 - North Region Materials Lab
Sample Organization Contact: (530) 225-3194
Type of Sample: Verification
Type of Material: Hot Mix Asphalt
Sample Taken Date: 02/16/2021
Date that the sample was received by the laboratory/organization performing the testing: 02/16/2021
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: 1/2-inch Type A HMA (PG 64-28 M)
From where was the sample collected: Manufacturer
Laboratory sample identification: D78745
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Mercer-Fraser Company, Willow Creek Plant, Willow Creek, CA

Material Information

HMA Type: Type A HMA
HMA Grading: 1/2 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2021-02-16-37-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Asphalt Binder Content)
Verified Date: 04/05/2021
Date Tested: 02/17/2021
Submitted By Organization: CT D02 - North Region Materials Lab
Organization Address: 1657 Riverside Dr,MS-83
Organization City: Redding
Organization State: CA
Organization Zipcode: 96001
Organization Email: ward.jenkins@dot.ca.gov
Organization Phone: (530) 225-3194
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A) 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B) 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A) 1.9 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B) 1.9 mm
Stripping Inflection Point (Wheel A) >25000
Stripping Inflection Point (Wheel B) >25000