Print Report | Back to Sample Detail

Sample Record for 2021-03-12-16

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 215307 DEA: 033F5004 EFIS: 0313000019 QA Service Level: 1
DIST-CO-RTE-PM: 03-GLE-5-R7.4/R17.0
Work Description: PLACE HMA (TYPE A) AND MODIFY INTERCONNECTION CONDUIT AND CABLE.
Location Description: GLENN COUNTY IN AND NEAR WILLOWS AT VARIOUS LOCATIONS FROM COUNTY ROAD 57 OVERCROSSING TO COUNTY ROAD 33 OVERCROSSING
Contractor Name: BALDWIN CONTRACTING COMPANY, INC. DBA KNIFE RIVER CONSTRUCT
Contractor Address: 1764 Skyway, CHICO, CA 95928
Resident Engineer: Tony Granados Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2021-03-12-16
TL Number from the TL Form: C778174
Sample Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Sample Organization Contact: (530) 741-4238
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 03/12/2021
Date that the sample was received by the laboratory/organization performing the testing: 03/12/2021
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: 3/4" sized untreated virgin aggregates
From where was the sample collected: Manufacturer
Laboratory sample identification: JMF21-003
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Knife River Construction - Orland Drum Plant

Material Information

Source Identification (SMARA, name of Pit or Job Site): 91-11-0007
The fabricator's/manufacturer's product name for the sample:
The fabricator/manufacturer designation for the sample:
The plant number:
A detailed description of where the material sample was collected: Cold Feed
Where the material sample would have been placed if not sampled:
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number:
Lot number:
Sublot number:
Aggregate Mix Number:

Test Results

Test 1 of 9

DIME Test ID: 2021-03-12-16-1
Test Method: AASHTO T335-09r13: Standard Method of Test for Determining the Percentage of Fracture in Coarse Aggregate (Percent of Crushed Particles)
Verified Date: 04/02/2021
Date Tested: 02/09/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-003
Method 2 - Individual Fracture Determination
Aggregate Size and Fracture Type Coarse 1 and 2 Faced and Fine 1 Faced
Weighted average percentage of fractured, coarse, 2 faced particles 94 %
Weighted average percentage of fractured, coarse, 1 faced particles 98 %
Percentage of fractured, fine, 1 faced particles tested 94 %

Test 2 of 9

DIME Test ID: 2021-03-12-16-2
Test Method: AASHTO T96-02r10: Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (Los Angeles Rattler)
Verified Date: 04/02/2021
Date Tested: 02/18/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003. Thomas Stinnett
Test Result Compliance: complies
Additional Comments When Verified: JMF21-003
Grading designation C
Percent loss after 100 revolutions 4 %
Percent loss after 500 revolutions 19 %

Test 3 of 9

DIME Test ID: 2021-03-12-16-3
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Verified Date: 04/02/2021
Date Tested: 02/04/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: The Sand Equivalent reported is 74, which is an average of three tests. The lab tester’s test card notes are not available. Therefore, the District 3 lab’s CEM-3513 reported value, 74, was used for all four of the entries submitted in DIME.
Sand Equivalent 74

Test 4 of 9

DIME Test ID: 2021-03-12-16-4
Test Method: AASHTO T304-11: Standard Method of Test for Uncompacted Void Content of Fine Aggregate (Fine of Crushed Particles)
Verified Date: 04/02/2021
Date Tested: 02/03/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-003
What test method is performed? Method A
Bulk dry specific gravity 2.655
Average uncompacted voids 46.3 %

Test 5 of 9

DIME Test ID: 2021-03-12-16-5
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Verified Date: 04/02/2021
Date Tested: 02/05/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: Weighted percentage of particles (by mass) that were flat and elongated * reported by the D-3 Lab = 1.2%. The DIME software requires a positive integer. Therefore, the lab test results have been rounded up or down accordingly, then submitted into DIME.
Method B
Determination By Mass
Dimensional ratio used 5:1
Weighted percentage of particles (by mass) that were flat and elongated 1 %
Weighted percentage of particles (by mass) that were not flat and elongated 99 %

Test 6 of 9

DIME Test ID: 2021-03-12-16-6
Test Method: CTM 204-June 2010: Method of Test for Liquid Limit, Plastic Limit and Plasticity Index of Soils (Plasticity Index)
Verified Date: 04/02/2021
Date Tested: 02/04/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: Per Lab MREA Jeff Herbert, no plastic in fine aggregate – no test performed.
Plastic Index(PI) NP
Liquid Limit (LL) 0 %
Plastic Limit (PL) 0 %

Test 7 of 9

DIME Test ID: 2021-03-12-16-7
Test Method: AASHTO T85-13: Standard Method of Test for Specific Gravity and Absorption of Coarse Aggregate (Coarse Specific Gravity)
Verified Date: 04/02/2021
Date Tested: 02/17/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: not applicable
Additional Comments When Verified: Report only
Basis for relative density testing Bulk
Specific Gravity 2.719
Absorption 1.2 %

Test 8 of 9

DIME Test ID: 2021-03-12-16-8
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 04/02/2021
Date Tested: 02/03/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: not applicable
Additional Comments When Verified: JMF21-003. Report only
Bulk specific gravity 2.655
Bulk specific gravity (SSD Basis) 2.698
Apparent specific gravity 2.776
Absorption 1.6 %

Test 9 of 9

DIME Test ID: 2021-03-12-16-9
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 04/02/2021
Date Tested: 02/02/2021
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF21-003.
Test Result Compliance: complies
Additional Comments When Verified: JMF21-003
What type of gradation is being tested? HMA Gradation
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 98 %
Cumulative percent passing the 1/2 in. sieve 78 %
Cumulative percent passing the 3/8 in. sieve 62 %
Cumulative percent passing the #4 sieve 44 %
Cumulative percent passing the #8 sieve 29 %
Cumulative percent passing the #16 sieve 18 %
Cumulative percent passing the #30 sieve 12 %
Cumulative percent passing the #50 sieve 7 %
Cumulative percent passing the #100 sieve 4 %
Cumulative percent passing the #200 sieve 2.7 %