Print Report | Back to Test Summary

Testing Report for 2021-03-10-6-5

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: JMFPP
EFIS: 0019000043
Project ID: 66667
QA Service Level:
DIST-CO-RTE-PM: 59---
Work Description: Special project for submitting Sample information for JMF Prequalification Program.
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2021-03-10-6
TL Number from the TL Form:
Sample Submitted By Organization: CT HQ - Hot Mix Asphalt Laboratory
Sample Organization Contact: (916) 227-7302
Type of Sample: Verification
Type of Material: Hot Mix Asphalt
Sample Taken Date: 3/10/2021
Date that the sample was received by the laboratory/organization performing the testing: 3/10/2021
The quantity of what the sample constitutes: 14 boxes
A brief description of the sample: 1/2" Type A HMA w WMA PG 64-16 15% RAP
From where was the sample collected: Supplier
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Syar Industries Inc

Material Information

HMA Type: Type A HMA
HMA Grading: 1/2 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2021-03-10-6-5
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Date Tested: 3/19/2021
Verified Date: 3/30/2021
Submitted By Organization: CT HQ - Hot Mix Asphalt Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: guadalupe.magana@dot.ca.gov
Organization Phone: (916) 227-7302
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): no data
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): no data
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): no data
Stripping Inflection Point (Wheel A): no data
Stripping Inflection Point (Wheel B): no data