Print Report | Back to Test Summary

Testing Report for 2020-09-02-39-6

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

DEA: 033H72U4
EFIS: 0320000087
Project ID: 214875
QA Service Level: 1
DIST-CO-RTE-PM: 03-BUT-70-5.6/9.1
Work Description: ROADWAY EXCAVATION, PLACE HMA & RHMA, & CONSTRUCT DRAINAGE SYSTEMS.
Location Description: BUTTE COUNTY NEAR OROVILLE FROM 0.2 MILE NORTH OF COX LANE TO 0.1 MILE NORTH OF PALERMO ROAD
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Dan Rechs
Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2020-09-02-39
TL Number from the TL Form:
Sample Submitted By Organization: CT D03 - North Region Materials Lab
Sample Organization Contact: (530) 741-4238
Type of Sample: Verification
Type of Material: Hot Mix Asphalt
Sample Taken Date: 9/2/2020
Date that the sample was received by the laboratory/organization performing the testing: 9/3/2020
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: 3/4" HMA - A w/RAP
From where was the sample collected: Manufacturer
Laboratory sample identification: JMF20-038
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Knife River Construction - Hallwood

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2020-09-02-39-6
Test Method: AASHTO T324-14: Standard Method of Test for Hamburg Wheel-Track Testing of Compacted Asphalt Mixtures (Hamburg Wheel Track)
Date Tested: 9/14/2020
Verified Date: 2/1/2021
Submitted By Organization: CT D03 - North Region Materials Lab
Organization Address: 5330 Arboga Rd,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: JMF20-038
Test Result Compliance: complies
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A): 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B): 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A): 7.08 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B): 7.29 mm
Stripping Inflection Point (Wheel A): 25000
Stripping Inflection Point (Wheel B): 25000