Print Report | Back to Test Summary

Testing Report for 2021-01-10-5-4

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 66667 DEA: JMFPP EFIS: 0019000043 QA Service Level:
DIST-CO-RTE-PM: 59---
Work Description: Special project for submitting Sample information for JMF Prequalification Program.
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2021-01-10-5
TL Number from the TL Form:
Sample Submitted By Organization: Syar Industries, Inc.
Sample Organization Contact: 707-259-5705
Type of Sample: Preliminary
Type of Material: Hot Mix Asphalt
Sample Taken Date: 01/10/2021
Date that the sample was received by the laboratory/organization performing the testing: 01/10/2021
The quantity of what the sample constitutes: 780 Pounds
A brief description of the sample: 3/4" HMA-SP WMA
From where was the sample collected: Manufacturer
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Syar Todd Road Batch

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number:
Sublot number:

Test Information

DIME Test ID: 2021-01-10-5-1
Test Method: AASHTO T209-12: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)
Verified Date: 03/18/2021
Date Tested: 01/10/2021
Submitted By Organization: Syar Industries, Inc.
Organization Address: 2301 Napa-Vallejo Hwy,P.O. Box 2540
Organization City: Napa
Organization State: CA
Organization Zipcode: 94558
Organization Email: mherlax@syar.com
Organization Phone: 707-259-5705
General Comments for this Test:
Additional Comments When Verified :

Submitted Test Results

Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel A) 25000
Specified minimum number of passes at ½” rut depth, or number of passes at ½” rut depth if applicable (Wheel B) 25000
Impression at specified number of passes, or specified maximum impression if applicable (Wheel A) 0 mm
Impression at specified number of passes, or specified maximum impression if applicable (Wheel B) 0 mm
Stripping Inflection Point (Wheel A) 0
Stripping Inflection Point (Wheel B) 0