Print Report | Back to Test Summary

Testing Report for 2018-02-27-21-7

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 212679 DEA: 023E7204 EFIS: 0200020154 QA Service Level: 1
DIST-CO-RTE-PM: 02-TEH-36-42.1/46.0
Work Description: COLD PLANING, PAVING, MINOR CONCRETE, ELECTRICAL AND STRIPING WORK.
Location Description: TEHAMA COUNTY IN AND NEAR RED BLUFF FROM EAST SAND SLOUGH BRIDGE TO 0.6 MILE EAST OF STICE ROAD
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Anthony Granados Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2018-02-27-21
TL Number from the TL Form: 852088
Sample Submitted By Organization: CT D02 - North Region Materials Lab
Sample Organization Contact: (530) 225-3194
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 02/27/2018
Date that the sample was received by the laboratory/organization performing the testing: 02/27/2018
The quantity of what the sample constitutes: JMF Verification
A brief description of the sample: Untreated Virgin 1/2-inch Type A Aggregate, Laboratory Combined
From where was the sample collected: Manufacturer
Laboratory sample identification: D77292F
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Tullis, Inc - Northstate Asphalt - Redding, CA

Material Information

Source Identification (SMARA or name of Pit): 91-45-0057::SHASTA RANCH AGGREGATES
The fabricator's/manufacturer's product name for the sample: Untreated Virgin 1/2-inch Type A
The fabricator/manufacturer designation for the sample: L170860
The plant number: Unknown
A detailed description of where the material sample was collected: Stockpiles at Plant
Where the material sample would have been placed if not sampled: Unknown
Primary Aggregate Nominal Size: 1/2 inch
The concrete mix design number: JMF 18-01-S1
Lot number:
Sublot number:

Test Information

DIME Test ID: 2018-02-27-21-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 07/16/2018
Date Tested: 02/27/2018
Submitted By Organization: CT D02 - North Region Materials Lab
Organization Address: 1657 Riverside Dr,MS-83
Organization City: Redding
Organization State: CA
Organization Zipcode: 96001
Organization Email: ward.jenkins@dot.ca.gov
Organization Phone: (530) 225-3194
General Comments for this Test:
Additional Comments When Verified :

Submitted Test Results

Size of aggregate being tested Coarse and Fine Aggregate
What type of solution was used? Sodium sulfate
What was the condition of the solution? Previously used
Number of immersion cycles performed 5
Coarse weighted average loss 1 %
Fine weighted average loss 3 %