Print Report | Back to Sample Detail

Sample Record for 2023-04-04-11

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 993184 DEA: 040A7724 EFIS: 0420000288 COOP: 042763 QA Service Level: 1
DIST-CO-RTE-PM: 04-ALA-80-6.4/6.8
Work Description: Excavation, HMA, structural concrete, minor concrete and drainage.
Location Description: IN BERKELEY AND ALBANY FROM 0.6 MILE NORTH OF UNIVERSITY AVENUE OVERCROSSING TO 0.3 MILE SOUTH OF EL CERRITO SEPARATION AND OVERHEAD
Contractor Name: OC Jones (Will Dieterich)
Contractor Address: 1520 Fourth Street, Berkeley, CA 94710
Resident Engineer: Maxime Dabilly Structure Rep.: Eric Urementa

Sample Information

DIME Sample ID: 2023-04-04-11
TL Number from the TL Form: C727178
Sample Submitted By Organization: CT D04 - Richmond Field Laboratory
Sample Organization Contact: (510) 231-7151
Type of Sample: Quality Assurance
Type of Material: Aggregate
Sample Taken Date: 04/04/2023
Date that the sample was received by the laboratory/organization performing the testing: 04/04/2023
The quantity of what the sample constitutes: Production Start Up Evaluation
A brief description of the sample: 3/4 HMA Type A
From where was the sample collected: Manufacturer
Laboratory sample identification: Rich_23_084
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Dutra Materials Richmond

Material Information

Source Identification (SMARA, name of Pit or Job Site): 91-21-0008
The fabricator's/manufacturer's product name for the sample: L210140WMA
The fabricator/manufacturer designation for the sample: Drum Plant
The plant number:
A detailed description of where the material sample was collected: Coldfeed
Where the material sample would have been placed if not sampled: Roadway
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number:
Lot number: 2
Sublot number: 1
Aggregate Mix Number: L210140WMA
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2023-04-04-11-1
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Verified Date: 04/24/2023
Date Tested: 04/05/2023
Submitted By Organization: CT D04 - Richmond Field Laboratory
Organization Address: 3401 Regatta Boulevard,
Organization City: Richmond
Organization State: CA
Organization Zipcode: 94508
Organization Email: santiago.sequeira@dot.ca.gov
Organization Phone: (510) 385-7641
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified:
Sand Equivalent 62

Test 2 of 2

DIME Test ID: 2023-04-04-11-2
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 04/24/2023
Date Tested: 04/05/2023
Submitted By Organization: CT D04 - Richmond Field Laboratory
Organization Address: 3401 Regatta Boulevard,
Organization City: Richmond
Organization State: CA
Organization Zipcode: 94508
Organization Email: santiago.sequeira@dot.ca.gov
Organization Phone: (510) 385-7641
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified:
What type of gradation is being tested? HMA Gradation
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 98 %
Cumulative percent passing the 1/2 in. sieve 87 %
Cumulative percent passing the 3/8 in. sieve 70 %
Cumulative percent passing the #4 sieve 48 %
Cumulative percent passing the #8 sieve 29 %
Cumulative percent passing the #16 sieve 19 %
Cumulative percent passing the #30 sieve 13 %
Cumulative percent passing the #50 sieve 9 %
Cumulative percent passing the #100 sieve 6 %
Cumulative percent passing the #200 sieve 3.6 %