Print Report | Back to Sample Detail

Sample Record for 2022-06-23-91

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 993300 DEA: 044J3004 EFIS: 0415000320 QA Service Level: 1
DIST-CO-RTE-PM: 04-NAP-29-29.3/36.9
Work Description: COLD PLANE AC, PLACE HMA (TYPE A) AND RHMA-G.
Location Description: NAPA COUNTY IN AND NEAR SAINT HELENA AND CALISTOGA FROM YORK CREEK BRIDGE TO ROUTE 128
Contractor Name: ARGONAUT CONSTRUCTION
Contractor Address: P. O. BOX 639, SANTA ROSA, CA 95402
Resident Engineer: Paramdeep Brar Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2022-06-23-91
TL Number from the TL Form:
Sample Submitted By Organization: CT D04 - Concord Field Laboratory
Sample Organization Contact: (510) 714-7019
Type of Sample: Verification
Type of Material: Hot Mix Asphalt
Sample Taken Date: 06/23/2022
Date that the sample was received by the laboratory/organization performing the testing: 06/23/2022
The quantity of what the sample constitutes: 70 tons
A brief description of the sample: 1/2" RHMA -G
From where was the sample collected: Supplier
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: BoDean Company Santa Rosa

Material Information

HMA Type: RHMA-G
HMA Grading: 1/2 inch
Lot number:
Sublot number:
HMA Mix Number: 600SPR16
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2022-06-23-91-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 03/22/2023
Date Tested: 06/30/2022
Submitted By Organization: CT D04 - Concord Field Laboratory
Organization Address: 2525 Stanwell Drive, Suite 100,
Organization City: Concord
Organization State: CA
Organization Zipcode: 94520
Organization Email: gurind.joshi@dot.ca.gov
Organization Phone: (510) 714-7019
General Comments for this Test: PLEASE RUN THE GRADING AND SE FOR JMF VERIFICATION
Test Result Compliance: complies
Additional Comments When Verified:
What type of gradation is being tested? Combined Gradation
Cumulative percent passing the 2 in. sieve 100 %
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 100 %
Cumulative percent passing the 1/2 in. sieve 99 %
Cumulative percent passing the 3/8 in. sieve 88 %
Cumulative percent passing the #4 sieve 35 %
Cumulative percent passing the #8 sieve 18 %
Cumulative percent passing the #16 sieve 10 %
Cumulative percent passing the #30 sieve 6 %
Cumulative percent passing the #50 sieve 4 %
Cumulative percent passing the #100 sieve 2 %
Cumulative percent passing the #200 sieve 1.2 %

Test 2 of 2

DIME Test ID: 2022-06-23-91-2
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 03/22/2023
Date Tested: 08/30/2022
Submitted By Organization: CT D04 - Concord Field Laboratory
Organization Address: 2525 Stanwell Drive, Suite 100,
Organization City: Concord
Organization State: CA
Organization Zipcode: 94520
Organization Email: gurind.joshi@dot.ca.gov
Organization Phone: (510) 714-7019
General Comments for this Test: TESTING THE DIME FOR BINDER CONTENT
Test Result Compliance: does not comply
Additional Comments When Verified:
What temperature unit is used? Fahrenheit
Test procedure used? Method B
Mass of the specimen basket assembly no data
Mass of the specimen and specimen basket assembly prior to ignition no data
Mass of HMA Sample prior to ignition 1566.5 g
Corrected Asphalt Binder Content 6.62 %
Mass Loss no data
Mass of aggregate remaining after ignition 1447.7 g
Correction Factor (Percent by mass of HMA Specimen) 0.96 %
Moisture Content 0.00 %
Temperature Compensation Factor no data
Test Temperature 538 F