Print Report | Back to Sample Detail

Sample Record for 2021-06-14-21

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 215415 DEA: 101L2204 EFIS: 1020000125 QA Service Level: 1
DIST-CO-RTE-PM: 10-AMA-88-14.4/15.0,16.7/17.0
Work Description: COLD PLANE, AND OVERLAY WITH HMA.
Location Description: AMADOR COUNTY IN AND NEAR JACKSON FROM BROADWAY TO 0.1 MILE EAST OF COURT STREET AND FROM ROCKY CREEK BRIDGE TO 0.1 MILE EAST OF DALTON ROAD
Contractor Name: GEORGE REED INC - MYERS AND SONS CONSTRUCTION LP JV
Contractor Address: 140 Empire Avenue, Modesto, CA 95352
Resident Engineer: Iqbal Aulakh Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2021-06-14-21
TL Number from the TL Form: 760563
Sample Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Sample Organization Contact: (916) 227-7302
Type of Sample: Acceptance
Type of Material: Asphalt Binder
Sample Taken Date: 06/14/2021
Date that the sample was received by the laboratory/organization performing the testing: 06/21/2021
The quantity of what the sample constitutes: 1 OF 1 CAN
A brief description of the sample: ASPHALT BINDER
From where was the sample collected: Source
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: MARATHON ELK GROVE

Material Information

Performance Grade: PG 64-16
Modified: No
Lot number:
Sublot number:
Tank number:
Time of sample:
HMA Supplier: GEORGE REED INC
Asphalt Binder Supplier: Marathon Petroleum Co. LP - Elk Grove CA
Multigrade: No
Multigrade Type:

Test Results

Test 1 of 3

DIME Test ID: 2021-06-14-21-1
Test Method: AASHTO T240-17: Standard Method of Test for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test)
Verified Date: 07/07/2021
Date Tested: 06/25/2021
Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: guadalupe.magana@dot.ca.gov
Organization Phone: (916) 227-7302
General Comments for this Test: Per 2018 Standard Specifications
Test Result Compliance: complies
Additional Comments When Verified:
Is mass change based on one or two containers? Two
Any material loss from containers during heating process/testing? No
Mass of empty container #1 170.018 grams
Mass of empty container #2 161.257 grams
Mass of container #1 before test (m1i) 205.040 grams
Mass of container #2 before test (m2i) 196.103 grams
Mass of container #1 after test (m1f) 204.946 grams
Mass of container #2 after test (m2f) 196.042 grams
Average mass change -0.222 percent

Test 2 of 3

DIME Test ID: 2021-06-14-21-2
Test Method: AASHTO T315-16: Standard Method of Test for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR) (Dynamic Shear)
Verified Date: 06/29/2021
Date Tested: 06/24/2021
Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: guadalupe.magana@dot.ca.gov
Organization Phone: (916) 227-7302
General Comments for this Test: ORIG
Test Result Compliance: complies
Additional Comments When Verified:
Phase Original binder
Test Plate Diameter 25 mm
Test Gap 1 mm
Test Frequency 10.0 rad/s
Strain Amplitude 12.00 %
Stress Amplitude 0.167 kPa
Phase Angle (δ) (for the 10 cycles) 87.3 degree
Complex Modulus (G*) (for the 10 measurements) 1.395 kPa
Test Temperature 64.0 C
Dynamic Shear, G*/sin(δ) 1.40 kPa

Test 3 of 3

DIME Test ID: 2021-06-14-21-3
Test Method: AASHTO T315-16: Standard Method of Test for Determining the Rheological Properties of Asphalt Binder Using a Dynamic Shear Rheometer (DSR) (Dynamic Shear)
Verified Date: 06/29/2021
Date Tested: 06/24/2021
Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: guadalupe.magana@dot.ca.gov
Organization Phone: (916) 227-7302
General Comments for this Test: RTFO
Test Result Compliance: complies
Additional Comments When Verified:
Phase RTFO residue
Test Plate Diameter 25 mm
Test Gap 1 mm
Test Frequency 10.0 rad/s
Strain Amplitude 10.00 %
Stress Amplitude 0.442 kPa
Phase Angle (δ) (for the 10 cycles) 83.1 degree
Complex Modulus (G*) (for the 10 measurements) 4.419 kPa
Test Temperature 64.0 C
Dynamic Shear, G*/sin(δ) 4.45 kPa

Tests Assigned to this Sample

DIME Test IDTest MethodAssigned DateTest DateAssigned ByAssigned LabTest CommentsAssigned To
No tests have been assigned to this sample.