Print Report | Back to Sample Detail

Sample Record for 2020-04-14-9

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 214587 DEA: 101J1604 EFIS: 1018000180 QA Service Level: 1
DIST-CO-RTE-PM: 10-STA-132-27.9/41.0
Work Description: COLD PLANE AC PAVEMENT, RHMA OVERLAY AND SLURRY SEAL.
Location Description: STANISLAUS COUNTY IN AND NEAR WATERFORD FROM G STREET TO 1.2 MILES EAST OF RUSHING ROAD
Contractor Name: George Reed
Contractor Address: PO Box, Greenwood, CA 95635
Resident Engineer: Ranbir Bhullar Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2020-04-14-9
TL Number from the TL Form: C033878
Sample Submitted By Organization: CT HQ - Hot Mix Asphalt Laboratory
Sample Organization Contact: (916) 227-7302
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 04/14/2020
Date that the sample was received by the laboratory/organization performing the testing: 04/15/2020
The quantity of what the sample constitutes: Bags of Aggregate for JMF
A brief description of the sample: Virgin aggregate for 1/2 Type A HMA mix
From where was the sample collected: Source
Laboratory sample identification: 20-JMF-0045
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: George Reed Inc

Material Information

Source Identification (SMARA or name of Pit): 91-55-0005::TABLE MOUNTAIN QUARRY
The fabricator's/manufacturer's product name for the sample:
The fabricator/manufacturer designation for the sample:
The plant number:
A detailed description of where the material sample was collected: Plant
Where the material sample would have been placed if not sampled:
Primary Aggregate Nominal Size: 1/2 inch
The concrete mix design number:
Lot number:
Sublot number:

Test Results

Test 1 of 8

DIME Test ID: 2020-04-14-9-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 04/23/2020
Date Tested: 04/17/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
What type of gradation is being tested? HMA Gradation
Does this test use 1/4 sieve? (question for HMA Gradation Type) No
Total mass of material in the sample 4894.1 grams
Cumulative mass retained on the 1 1/2 in. sieve 0 grams
Cumulative mass retained on the 1 in. sieve 0 grams
Cumulative mass retained on the 3/4 in. sieve 0 grams
Cumulative mass retained on the 1/2 in. sieve 219.5 grams
Cumulative mass retained on the 3/8 in. sieve 772.2 grams
Cumulative mass retained on the #4 sieve 2207.8 grams
Total sample mass passing the #4 sieve 2686.3 grams
Total mass of fine material in the sample 679.4 grams
Cumulative mass retained on the #8 sieve 207 grams
Cumulative mass retained on the #16 sieve 343.2 grams
Cumulative mass retained on the #30 sieve 452.7 grams
Cumulative mass retained on the #50 sieve 539.9 grams
Cumulative mass retained on the #100 sieve 595.8 grams
Cumulative mass retained on the #200 sieve 625.3 grams
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 100 %
Cumulative percent passing the 1/2 in. sieve 95.5 %
Cumulative percent passing the 3/8 in. sieve 84.2 %
Cumulative percent passing the #4 sieve 54.9 %
Cumulative percent passing the #8 sieve 38.2 %
Cumulative percent passing the #16 sieve 27.2 %
Cumulative percent passing the #30 sieve 18.3 %
Cumulative percent passing the #50 sieve 11.3 %
Cumulative percent passing the #100 sieve 6.8 %
Cumulative percent passing the #200 sieve 4.37 %

Test 2 of 8

DIME Test ID: 2020-04-14-9-2
Test Method: AASHTO T335-09r13: Standard Method of Test for Determining the Percentage of Fracture in Coarse Aggregate (Percent of Crushed Particles)
Verified Date: 04/23/2020
Date Tested: 04/20/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Method 1 - Combined Fracture Determination
Aggregate Size and Fracture Type Coarse 1 and 2 Faced and Fine 1 Faced
Percentage of questionable, coarse, 2 faced particles tested 0 %
Percentage of questionable, coarse, 1 faced particles tested 0 %
Percentage of questionable, fine, 1 faced particles tested 0 %
Percentage of fractured, coarse, 2 faced particles tested 100 %
Percentage of fractured, coarse, 1 faced particles tested 100 %
Percentage of fractured, fine, 1 faced particles tested 100 %

Test 3 of 8

DIME Test ID: 2020-04-14-9-3
Test Method: AASHTO T96-02r10: Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (Los Angeles Rattler)
Verified Date: 04/23/2020
Date Tested: 04/20/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Grading designation C
Mass of sample on No.12 sieve (after 500 revolutions) 3775 grams
Percent loss after 100 revolutions 5 %
Percent loss after 500 revolutions 25 %

Test 4 of 8

DIME Test ID: 2020-04-14-9-4
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Verified Date: 04/23/2020
Date Tested: 04/17/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Sand Equivalent 77

Test 5 of 8

DIME Test ID: 2020-04-14-9-5
Test Method: AASHTO T304-11: Standard Method of Test for Uncompacted Void Content of Fine Aggregate (Fine of Crushed Particles)
Verified Date: 04/23/2020
Date Tested: 04/20/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
What test method is performed? Method A
Bulk dry specific gravity 2.572
Average uncompacted voids 44.7 %

Test 6 of 8

DIME Test ID: 2020-04-14-9-6
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Verified Date: 04/23/2020
Date Tested: 04/21/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Method B
Determination By Number
Dimensional ratio used 5:1
Weighted percentage of particles (by number) that were flat and elongated 0 %
Weighted percentage of particles (by number) that were not flat and elongated 100 %

Test 7 of 8

DIME Test ID: 2020-04-14-9-7
Test Method: AASHTO T85-13: Standard Method of Test for Specific Gravity and Absorption of Coarse Aggregate (Coarse Specific Gravity)
Verified Date: 04/23/2020
Date Tested: 04/20/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Basis for relative density testing Bulk
Specific Gravity 2.627
Absorption 1.2 %

Test 8 of 8

DIME Test ID: 2020-04-14-9-8
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 04/23/2020
Date Tested: 04/20/2020
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: bang.d.nguyen@dot.ca.gov
Organization Phone: (916) 227-7204
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Bulk specific gravity 2.572
Bulk specific gravity (SSD Basis) 2.619
Apparent specific gravity 2.699
Absorption 1.8 %

Tests Assigned to this Sample

DIME Test IDTest MethodAssigned DateTest DateAssigned ByAssigned LabTest CommentsAssigned To
No tests have been assigned to this sample.