Print Report | Back to Sample Detail

Sample Record for 2019-05-15-12

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 213527 DEA: 081E5604 EFIS: 0814000050 QA Service Level: 1
DIST-CO-RTE-PM: 08---
Work Description:
Location Description:
Contractor Name: Autoban Construction, Inc
Contractor Address: 933 N Batavia St, Orange, CA 92867
Resident Engineer: George Samer Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2019-05-15-12
TL Number from the TL Form:
Sample Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Acceptance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 05/15/2019
Date that the sample was received by the laboratory/organization performing the testing: 05/20/2019
The quantity of what the sample constitutes: 125 tons out
A brief description of the sample: 3/4" HMA-A R15 PG 64-28M (0.75% LAS)
From where was the sample collected: Source
Laboratory sample identification: 0285A-19
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Vulcan-Oro Grande

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number: Unknown
Sublot number: Unknown
HMA Mix Number:
Test results on following page(s): 1

Test Results

Test 1 of 1

DIME Test ID: 2019-05-15-12-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 05/23/2019
Date Tested: 05/22/2019
Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Organization Address: 13970 Victoria Street,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email: jose.guzman@dot.ca.gov
Organization Phone: 9098293029
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Fahrenheit
Test procedure used? Method A
Mass of HMA Sample prior to ignition no data
Corrected Asphalt Binder Content 4.62 %
Mass Loss no data
Correction Factor (Percent by mass of HMA Specimen) no data
Moisture Content no data
Temperature Compensation Factor no data
Test Temperature no data