Print Report | Back to Sample Detail

Sample Record for 2017-12-15-4

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 99999 DEA: 0322222 QA Service Level:
DIST-CO-RTE-PM: 03-SAC,OMG-888,99,80-0.6-0.6
Work Description: THIS PROJECT RECORD WAS ADDED FOR DIME TESTERS - DATA SUBMITTED FOR THIS PROJECT SHOULD NOT BE USED FOR ANY OTHER PURPOSES.
Location Description: THIS PROJECT RECORD WAS ADDED FOR DIME TESTERS - DATA SUBMITTED FOR THIS PROJECT SHOULD NOT BE USED FOR ANY OTHER PURPOSES.
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2017-12-15-4
TL Number from the TL Form: Unknown
Sample Submitted By Organization: CT QAM - Sacramento Field Laboratory
Sample Organization Contact: (916) 227-7266
Type of Sample: Verification
Type of Material: Aggregate
Sample Taken Date: 12/15/2017
Date that the sample was received by the laboratory/organization performing the testing: 12/15/2017
The quantity of what the sample constitutes: TEST
A brief description of the sample: TEST
From where was the sample collected: Other
Laboratory sample identification: Unknown
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: TEST

Material Information

Source Identification (SMARA or name of Pit): TEST
The fabricator's/manufacturer's product name for the sample: Unknown
The fabricator/manufacturer designation for the sample: Unknown
The plant number: Unknown
A detailed description of where the material sample was collected: TEST
Where the material sample would have been placed if not sampled: Unknown
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number: Unknown
Lot number:
Sublot number:

Test Results

Test 1 of 14

DIME Test ID: 2017-12-15-4-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
What type of gradation is being tested? HMA Gradation
Does this test use 1/4 sieve? (question for HMA Gradation Type) Yes
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 98 %
Cumulative percent passing the 1/2 in. sieve 76 %
Cumulative percent passing the 3/8 in. sieve 61 %
Cumulative percent passing the 1/4 in. sieve 61 %
Cumulative percent passing the #4 sieve 44 %
Cumulative percent passing the #8 sieve 34 %
Cumulative percent passing the #16 sieve 26 %
Cumulative percent passing the #30 sieve 19 %
Cumulative percent passing the #50 sieve 12 %
Cumulative percent passing the #100 sieve 6 %
Cumulative percent passing the #200 sieve 3.1 %

Test 2 of 14

DIME Test ID: 2017-12-15-4-2
Test Method: AASHTO T335-09r13: Standard Method of Test for Determining the Percentage of Fracture in Coarse Aggregate (Percent of Crushed Particles)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Method 2 - Individual Fracture Determination
Aggregate Size and Fracture Type Coarse 1 and 2 Faced and Fine 1 Faced
Weighted average percentage of fractured, coarse, 2 faced particles 96 %
Weighted average percentage of fractured, coarse, 1 faced particles 98 %
Percentage of fractured, fine, 1 faced particles tested 100 %

Test 3 of 14

DIME Test ID: 2017-12-15-4-3
Test Method: AASHTO T96-02r10: Standard Method of Test for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine (Los Angeles Rattler)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Grading designation A
Percent loss after 100 revolutions 6 %
Percent loss after 500 revolutions 28 %

Test 4 of 14

DIME Test ID: 2017-12-15-4-4
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
Data has not been verified.

Test 5 of 14

DIME Test ID: 2017-12-15-4-5
Test Method: AASHTO T304-11: Standard Method of Test for Uncompacted Void Content of Fine Aggregate (Fine of Crushed Particles)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
What test method is performed? Method A
Bulk dry specific gravity 2.666
Average uncompacted voids 48 %

Test 6 of 14

DIME Test ID: 2017-12-15-4-6
Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Sand Equivalent 81

Test 7 of 14

DIME Test ID: 2017-12-15-4-7
Test Method: ASTM D4791-10: Standard Test Method for Flat Particles, Elongated Particles, or Flat and Elongated Particles in Coarse Aggregate (Withdrawn 2019) (Flat and Elongated Particles)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Method A
Determination By Mass
Dimensional ratio used 1:5
Weighted percentage of particles (by mass) that were flat 1 %
Weighted percentage of particles (by mass) that were elongated 1 %
Weighted percentage of particles (by mass) that were both flat and elongated 1 %
Weighted percentage of particles (by mass) that were neither flat nor elongated 1 %

Test 8 of 14

DIME Test ID: 2017-12-15-4-8
Test Method: CTM 204-June 2010: Method of Test for Liquid Limit, Plastic Limit and Plasticity Index of Soils (Plasticity Index)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Plastic Index(PI) 1
Liquid Limit (LL) 0 %
Plastic Limit (PL) 0 %

Test 9 of 14

DIME Test ID: 2017-12-15-4-9
Test Method: CTM 204-June 2010: Method of Test for Liquid Limit, Plastic Limit and Plasticity Index of Soils (Plasticity Index)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Plastic Index(PI) NP
Liquid Limit (LL) 0 %
Plastic Limit (PL) 0 %

Test 10 of 14

DIME Test ID: 2017-12-15-4-10
Test Method: AASHTO T85-13: Standard Method of Test for Specific Gravity and Absorption of Coarse Aggregate (Coarse Specific Gravity)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Basis for relative density testing Bulk
Specific Gravity 2.666
Absorption 0.8 %

Test 11 of 14

DIME Test ID: 2017-12-15-4-11
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Bulk specific gravity 2.674
Bulk specific gravity (SSD Basis) 2.698
Apparent specific gravity 2.674
Absorption 0.9 %

Test 12 of 14

DIME Test ID: 2017-12-15-4-12
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Bulk specific gravity 2.674
Bulk specific gravity (SSD Basis) 2.698
Apparent specific gravity 0.000
Absorption 0.9 %

Test 13 of 14

DIME Test ID: 2017-12-15-4-13
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Bulk specific gravity 2.674
Bulk specific gravity (SSD Basis) 2.698
Apparent specific gravity 1.000
Absorption 0.9 %

Test 14 of 14

DIME Test ID: 2017-12-15-4-14
Test Method: AASHTO T84-14: Standard Method of Test for Specific Gravity and Absorption of Fine Aggregate (Fine Specific Gravity)
Verified Date: 12/15/2017
Date Tested: 12/15/2017
Submitted By Organization: CT QAM - Sacramento Field Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: brett.soldano@dot.ca.gov
Organization Phone: (916) 227-7266
General Comments for this Test:
Additional Comments When Verified:
Bulk specific gravity 2.674
Bulk specific gravity (SSD Basis) 2.698
Apparent specific gravity 2.674
Absorption 0.9 %

Tests Assigned to this Sample

DIME Test IDTest MethodAssigned DateTest DateAssigned ByAssigned LabTest CommentsAssigned To
No tests have been assigned to this sample.