Print Report | Back to Sample Detail

Sample Record for 2017-07-05-5

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 212307 DEA: 044J6004 EFIS: 0415000370 QA Service Level: 1
DIST-CO-RTE-PM: 04-MRN-1,37&101-Var
Work Description: PLACE POLYESTER CONCRETE AND REPLACE JOINT SEALS.
Location Description: MARIN COUNTY AT VARIOUS LOCATIONS
Contractor Name: TRUESDELL CORPORATION OF CALIFORNIA, INC.
Contractor Address: Unknown
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2017-07-05-5
TL Number from the TL Form: Sacramento Caltrans lab
Sample Submitted By Organization: Kwik Bond Polymers
Sample Organization Contact: 760-518-6064
Type of Sample: Quality Control
Type of Material: Polyester
Sample Taken Date: 07/05/2017
Date that the sample was received by the laboratory/organization performing the testing: 07/05/2017
The quantity of what the sample constitutes: 4 tankers
A brief description of the sample: 1 gallon can
From where was the sample collected: Source
Laboratory sample identification: Unknown
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Kwik bond and Reichhold

Material Information

Mfg. Lot Number(s): 1042328
Batch number: 1042328
Mix number: 1042328

Test Results

Test 1 of 1

DIME Test ID: 2017-07-05-5-1
Test Method: CONCLP 3-16: Polyester Resin
Verified Date: 10/06/2017
Date Tested: 10/06/2017
Submitted By Organization: CT HQ - Sacramento Concrete Testing Laboratory
Organization Address: 5900 Folsom Blvd,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: larry.mccrum@dot.ca.gov
Organization Phone: (916) 227-7283
General Comments for this Test: Accepted QC results from supplier
Test Result Compliance: complies
Additional Comments When Verified:
Viscosity ASTM D 2196, RVT, No. 1 spindle 75 to 200 cps @ 20 RPM, 77°F 93 cps
Specific gravity ASTM D 1475 1.05 to 1.10 @ 77°F 1.09
Conditioning (18/25/50 + 5/70) Elogation ASTM D 638, minimum 35% 56.5 %
Tensile Strength ASTM D 638 Type 1 @ 0.45 in/min, minimum 2500 psi 3242 psi
Styrene ASTM D 2369 40% to 50 % 46 %
PCC - SSD bond strength CTM 551 500 psi minimun @ 24 hours 566 psi
Static Volatile Emissions, SCAQMD 309-91, maximum loss 1.0 grams 0.4 grams

Tests Assigned to this Sample

DIME Test IDTest MethodAssigned DateTest DateAssigned ByAssigned LabTest CommentsAssigned To
No tests have been assigned to this sample.