Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.
Project ID: 993671 DEA: 07357704 EFIS: 0719000097 COOP: 075245
QA Service Level: 2
DIST-CO-RTE-PM: 07-LA-I-210-
Work Description:
Location Description:
Contractor Name: Unknown
Contractor Address: Unknown
Resident Engineer: Mark Amorsolo Structure Rep.: Jinrong Wang
DIME Sample ID: 2024-04-19-72
TL Number from the TL Form:
Sample Submitted By Organization: Sequoia Consultants
Sample Organization Contact: (714) 974-6316
Type of Sample: Quality Control
Type of Material: Concrete
Sample Taken Date: 04/19/2024
Date that the sample was received by the laboratory/organization performing the testing: 04/20/2024
The quantity of what the sample constitutes: 2 cylinders
A brief description of the sample: structural concrete
From where was the sample collected: Job Site
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: National ready Mix
The concrete mix design number: S63C453T10
The truck number from where the sample was collected:
The batch plant ticket number from where the sample was collected: 323548
Concrete batch plant:
The fabricator/manufacturer designation for the sample:
A detailed description of where the material sample was collected: Middle Section of SW 352 STA 169+65-170+40
Where the material sample would have been placed if not sampled:
From Lot No.:
Bag Lot No.:
DIME Test ID: 2024-04-19-72-1
Test Method: ASTM C39-18: Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens
Verified Date: 09/03/2024
Date Tested: 05/17/2024
Submitted By Organization: Sequoia Consultants
Organization Address: 361 West Grove Avenue,
Organization City: Orange
Organization State: CA
Organization Zipcode: 92865
Organization Email: sranjan@sequoiacon.com
Organization Phone: 1 (714) 974-6316
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
|
Unit system used?
|
US Units
|
|
Number of specimens
|
2
|
|
Test performed
|
With no density determined
|
|
Average diameter of cylinder 1
|
6.00 in
|
|
Average diameter of cylinder 2
|
6.00 in
|
|
Capped in accordance with?
|
ASTM C617 - Sulfur Mortar Cap
|
|
Cross sectional area of cylinder 1
|
28.27 in^2
|
|
Cross sectional area of cylinder 2
|
28.27 in^2
|
|
Compressive strength (to nearest 10 psi)
|
4500 psi
|
|
Maximum load on cylinder 1
|
127680 lb
|
|
Maximum load on cylinder 2
|
126670 lb
|
|
Type of fracture pattern of cylinder 1
|
2
|
|
Type of fracture pattern of cylinder 2
|
2
|
|
Comment on any defect in either specimen or caps (Max 250 Characters)
|
no data
|
|
Correction factor for cylinder 1
|
1.00
|
|
Correction factor for cylinder 2
|
1.00
|
|
Age of specimen
|
28 days
|
|
Age of specimen in hours
|
no data0 hours
|
