Print Report | Back to Sample Detail

Sample Record for 2024-07-31-75

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 1000090 DEA: 024J9204 EFIS: 0223000087 QA Service Level: 1
DIST-CO-RTE-PM: 02-TRI-299-61.0/64.0,70.0/72.2
Work Description: ASPHALT RUBBER CHIP SEAL WITH REPLACE ASPHALT CONCRETE SURFACING.
Location Description: TRINITY COUNTY NEAR DOUGLAS CITY FROM STEEL BRIDGE ROAD TO 1.5 MILES WEST OF GRASS VALLEY CREEK BRIDGE NO 05-0013 AND FROM 2.6 MILES EAST OF TRINITY DAM BOULEVARD TO THE SHASTA COUNTY LINE
Contractor Name: AMERICAN PAVEMENT SYSTEMS, INC.
Contractor Address: Unknown
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2024-07-31-75
TL Number from the TL Form: 858505
Sample Submitted By Organization: CT D02 - Redding Northern Regional Laboratory
Sample Organization Contact: (530) 225-3194
Type of Sample: Production Start-Up
Type of Material: Aggregate
Sample Taken Date: 07/31/2024
Date that the sample was received by the laboratory/organization performing the testing: 07/31/2024
The quantity of what the sample constitutes: 1 Bag Coldfeed
A brief description of the sample: 1/2-inch Cold feed
From where was the sample collected: Manufacturer
Laboratory sample identification: D79676A
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Tullis Inc. - Northstate Asphalt (Redding CA)

Material Information

Source Identification (SMARA, name of Pit or Job Site): 91-45-0061
The fabricator's/manufacturer's product name for the sample:
The fabricator/manufacturer designation for the sample:
The plant number:
A detailed description of where the material sample was collected: Plant
Where the material sample would have been placed if not sampled:
Primary Aggregate Nominal Size: 1/2 inch
The concrete mix design number:
Lot number:
Sublot number:
Aggregate Mix Number:

Test Results

Test 1 of 1

DIME Test ID: 2024-07-31-75-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 08/20/2024
Date Tested: 08/15/2024
Submitted By Organization: CT D02 - Redding Northern Regional Laboratory
Organization Address: 1657 Riverside Drive,
Organization City: Redding
Organization State: CA
Organization Zipcode: 96001
Organization Email: ward.jenkins@dot.ca.gov
Organization Phone: 530-225-3194
General Comments for this Test:
Test Result Compliance: not applicable
Additional Comments When Verified:
What type of gradation is being tested? HMA Gradation
Cumulative percent passing the 2 in. sieve no data
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 100 %
Cumulative percent passing the 1/2 in. sieve 93 %
Cumulative percent passing the 3/8 in. sieve 81 %
Cumulative percent passing the #4 sieve 51 %
Cumulative percent passing the #8 sieve 32 %
Cumulative percent passing the #16 sieve 21 %
Cumulative percent passing the #30 sieve 14 %
Cumulative percent passing the #50 sieve 10 %
Cumulative percent passing the #100 sieve 7 %
Cumulative percent passing the #200 sieve 5.3 %