Print Report | Back to Sample Detail

Sample Record for 2024-06-06-64

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 993382 DEA: 031H2404 EFIS: 0316000077 QA Service Level: 1
DIST-CO-RTE-PM: 03-PLA-49-2.2/2.4
Work Description: REALIGN ROADWAY, CONSTRUCT ROUNDABOUT AND RELOCATE SEWER LINES.
Location Description: PLACER COUNTY IN AUBURN FROM 0.1 MILE SOUTH OF THE INTERSECTION OF ROUTE 49 AND LINCOLN WAY / BORLAND AVENUE TO LINCOLN WAY
Contractor Name: LAMON CONSTRUCTION
Contractor Address: 871 Von Geldern Way, Yuba City, cA 95991
Resident Engineer: Andrew Martin Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2024-06-06-64
TL Number from the TL Form: C765373
Sample Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Sample Organization Contact: (530) 741-4238
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 06/06/2024
Date that the sample was received by the laboratory/organization performing the testing: 06/10/2024
The quantity of what the sample constitutes: 3/4" HMA-SP w/ 15%RAP
A brief description of the sample: 2 Boxes HMA
From where was the sample collected: Source
Laboratory sample identification: Daily 24-030
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Teichert Hallwood

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number:
Sublot number:
HMA Mix Number:
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2024-06-06-64-1
Test Method: AASHTO T209-22: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)
Verified Date: 06/10/2024
Date Tested: 06/10/2024
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: Daily 24-030 JMF24-004
Test Result Compliance: not applicable
Additional Comments When Verified:
Number of Samples 1
What is the unit of measurement for theoretical density? SI Units
Mass Determination Air
Specific Gravity for Sample 1 2.585
Theoretical maximum density at 25°C (77°F) 3 kg/m^3

Test 2 of 2

DIME Test ID: 2024-06-06-64-2
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 06/10/2024
Date Tested: 06/10/2024
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: Daily 24-030 JMF 24-004
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of HMA Sample prior to ignition 2157.9 g
Corrected Asphalt Binder Content 4.56 %
Mass Loss 109.5 g
Correction Factor (Percent by mass of HMA Specimen) 0.51 %
Moisture Content no data0 %
Temperature Compensation Factor 0.02 %
Test Temperature 538 C