Project Information

Project ID: 993628 DEA: 081M0504 EFIS: 0821000064 QA Service Level: 1

DIST-CO-RTE-PM: 08-RIV-15,215-23.9/33.4,R8.4/41.5

Work Description: COLD PLANE AC PVMT, RHMA, AND REPLACE ASPHALT CONCRETE SURFACING.

Location Description: RIVERSIDE COUNTY ON ROUTE 15 FROM 0.1 MILE NORTH OF NICHOLS ROAD OVERCROSSING TO 0.1 MILE NORTH OF TEMESCAL CANYON ROAD UNDERCROSSING AND ON ROUTE 215 FROM 1.1 MILES SOUTH OF MURRIETA HOT SPRINGS ROAD UNDERCROSSING TO UNIVERSITY AVENUE UNDERCROSSING.

Contractor Name: ALL AMERICAN ASPHALT

Contractor Address: Unknown

Resident Engineer: BERGEVIN MICHAEL Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2022-08-08-60

TL Number from the TL Form:

Sample Submitted By Organization: CT D08 - Fontana Field Testing Laboratory

Sample Organization Contact: 9512323690

Type of Sample: Department Acceptance

Type of Material: Aggregate

Sample Taken Date: 08/08/2022

Date that the sample was received by the laboratory/organization performing the testing: 08/08/2022

The quantity of what the sample constitutes: 1 Bags Of Combined Aggregate

A brief description of the sample: 3/4" RHMA-G-SP

From where was the sample collected: Manufacturer

Laboratory sample identification: 0476G-22

Structure unique identifier:

Structure name:

The fabricator/manufacturer/facility name: All American Asphalt - Corona

Material Information

Source Identification (SMARA, name of Pit or Job Site): 91-33-0005

The fabricator's/manufacturer's product name for the sample:

The fabricator/manufacturer designation for the sample:

The plant number: 106835

A detailed description of where the material sample was collected: Belt Cut at All American Corona Plant

Where the material sample would have been placed if not sampled:

Primary Aggregate Nominal Size: 3/4 inch

The concrete mix design number:

Lot number:

Sublot number:

Aggregate Mix Number:

Test Results

Test 1 of 2

DIME Test ID: 2022-08-08-60-1

Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)

Verified Date: 09/19/2022

Date Tested: 08/08/2022

Submitted By Organization: CT D08 - Fontana Field Testing Laboratory

Organization Address: 13970 Victoria Street,

Organization City: Fontana

Organization State: CA

Organization Zipcode: 92336

Organization Email: prakash.gowda@dot.ca.gov

Organization Phone: (951) 232-3690

General Comments for this Test:

Test Result Compliance: complies

Additional Comments When Verified:

What type of gradation is being tested?	Combined Gradation
Cumulative percent passing the 2 in. sieve	100 %
Cumulative percent passing the 1 1/2 in. sieve	100 %
Cumulative percent passing the 1 in. sieve	100 %
Cumulative percent passing the 3/4 in. sieve	97 %
Cumulative percent passing the 1/2 in. sieve	79 %
Cumulative percent passing the 3/8 in. sieve	60 %
Cumulative percent passing the #4 sieve	28 %
Cumulative percent passing the #8 sieve	17 %
Cumulative percent passing the #16 sieve	12 %
Cumulative percent passing the #30 sieve	9 %
Cumulative percent passing the #50 sieve	6 %
Cumulative percent passing the #100 sieve	4 %
Cumulative percent passing the #200 sieve	3 %

Test 2 of 2

DIME Test ID: 2022-08-08-60-2

Test Method: AASHTO T176-08: Standard Method of Test for Plastic Fines in Graded Aggregates and Soils by Use of the Sand Equivalent Test (Sand Equivalent)