Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.
Project ID: 213654 DEA: 060T20U4 EFIS: 0619000008
QA Service Level: 1
DIST-CO-RTE-PM: 06-KER-99-L0.0/11.2
Work Description: REPLACE JPCP LANES WITH CONTINUOUSLY REINFORCED CONCRETE PAVEMENT.
Location Description: KERN COUNTY NEAR WHEELER RIDGE FROM 0.8 MILE SOUTH OF ROUTE 5/99 SEPARATION TO 0.3 MILE NORTH OF OLD US 99 OVERCROSSING
Contractor Name: GRIFFITH-VANGUARD JOINT VENTURE
Contractor Address: 1128 Carrier Parkway Ave, Bakersfield, CA 93308
Resident Engineer: Kris Raber Structure Rep.: Mark Wittgraf
DIME Sample ID: 2020-05-19-30
TL Number from the TL Form: 771778
Sample Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Sample Organization Contact: (916) 227-7302
Type of Sample: Department Acceptance
Type of Material: Asphalt Binder
Sample Taken Date: 05/19/2020
Date that the sample was received by the laboratory/organization performing the testing: 05/28/2020
The quantity of what the sample constitutes: 1 Can
A brief description of the sample: Asphalt Binder Sample
From where was the sample collected: Distributor
Laboratory sample identification: AB206006
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Griffith Edmonston
Performance Grade: PG70-10
Modified: No
Lot number:
Sublot number:
Tank number:
Time of sample:
HMA Supplier:
Certified Asphalt Supplier:
Multigrade:
Multigrade Type:
Asphalt Binder Mix Number:
DIME Test ID: 2020-05-19-30-1
Test Method: AASHTO T240-17: Standard Method of Test for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test)
Verified Date: 06/15/2020
Date Tested: 06/15/2020
Submitted By Organization: CT HQ - Sacramento Asphalt Binder Laboratory
Organization Address: 5900 Folsom Boulevard,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: guadalupe.magana@dot.ca.gov
Organization Phone: (530) 713-6823
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified:
|
Is mass change based on one or two containers?
|
One
|
|
Any material loss from containers during heating process/testing?
|
No
|
|
Mass of empty container #1
|
174.71 grams
|
|
Mass of container #1 before test (m1i)
|
209.736 grams
|
|
Mass of container #1 after test (m1f)
|
209.72 grams
|
|
Average mass change
|
-0.046 percent
|