Print Report | Back to Sample Detail

Sample Record for 2019-09-18-22

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 214122 DEA: 081G1204 QA Service Level: 1
DIST-CO-RTE-PM: 08-RIV-243-13.3/29.7
Work Description: COLD PLANE AC, PLACE RHMA-G AND RECESSED THERMOPLASTIC TRAFFIC STRIPE.
Location Description: RIVERSIDE COUNTY IN AND NEAR BANNING FROM 0.7 MILE NORTH OF BLACK MOUNTAIN TRAIL TO ROUTE 243/10 SEPARATION
Contractor Name: MATICH CORPORATION
Contractor Address: 1596 HARRY SHEPPARD BLVD, SAN BERNARDINO CA 92408
Resident Engineer: JONATHAN SKEITH Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2019-09-18-22
TL Number from the TL Form:
Sample Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Department Acceptance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 09/18/2019
Date that the sample was received by the laboratory/organization performing the testing: 09/26/2019
The quantity of what the sample constitutes: 2 boxes
A brief description of the sample: 3/4" RHMA-G
From where was the sample collected: Manufacturer
Laboratory sample identification: 0567G-19
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Matich-Cabazon

Material Information

HMA Type: RHMA-G
HMA Grading: 3/4 inch
Lot number: Unknown
Sublot number: Unknown
HMA Mix Number:

Test Results

Test 1 of 1

DIME Test ID: 2019-09-18-22-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 10/07/2019
Date Tested: 09/27/2019
Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Organization Address: 13970 Victoria Street,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email: jose.guzman@dot.ca.gov
Organization Phone: (909) 829-3029
General Comments for this Test:
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Fahrenheit
Test procedure used? Method A
Mass of HMA Sample prior to ignition no data
Corrected Asphalt Binder Content 7.43 %
Mass Loss no data
Correction Factor (Percent by mass of HMA Specimen) no data
Moisture Content no data
Temperature Compensation Factor no data
Test Temperature no data