Print Report | Back to Sample Detail

Sample Record for 2019-07-25-11

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 213283 DEA: 060U09U4 EFIS: 0616000243 QA Service Level: 1
DIST-CO-RTE-PM: 06-FRE-168-R36.0/65.9
Work Description: HMA RESURFACING AND REHAB CULVERTS
Location Description: FRESNO COUNTY IN AND NEAR SHAVER LAKE FROM 0.2 MILE WEST OF AUBERRY ROAD TO KAISER PASS ROAD
Contractor Name: Cal Valley Construction
Contractor Address: 5125 N. Gates Ave., Ste. 102, Fresno, CA, 93722-6414
Resident Engineer: Mark Mengoni Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2019-07-25-11
TL Number from the TL Form: C236012
Sample Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Sample Organization Contact: (915) 296-1892
Type of Sample: Per Request
Type of Material: Aggregate
Sample Taken Date: 07/25/2019
Date that the sample was received by the laboratory/organization performing the testing: 08/23/2019
The quantity of what the sample constitutes: 1 bag
A brief description of the sample: 3/4" combine agg
From where was the sample collected: Other
Laboratory sample identification: 19-HMA-0134
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Plant Valcan

Material Information

Source Identification (SMARA, name of Pit or Job Site): Vulcan
The fabricator's/manufacturer's product name for the sample: Unknown
The fabricator/manufacturer designation for the sample: Unknown
The plant number: Unknown
A detailed description of where the material sample was collected: Ashland
Where the material sample would have been placed if not sampled: Unknown
Primary Aggregate Nominal Size: 3/4 inch
The concrete mix design number: Unknown
Lot number: Unknown
Sublot number: Unknown
Aggregate Mix Number:
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2019-07-25-11-1
Test Method: AASHTO T27-14: Standard Method of Test for Sieve Analysis of Fine and Coarse Aggregates (Sieve Analysis)
Verified Date: 08/28/2019
Date Tested: 08/28/2019
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Boulevard,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: ryan.kester@dot.ca.gov
Organization Phone: (916) 227-7215
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
What type of gradation is being tested? HMA Gradation
Cumulative percent passing the 2 in. sieve no data
Cumulative percent passing the 1 1/2 in. sieve 100 %
Cumulative percent passing the 1 in. sieve 100 %
Cumulative percent passing the 3/4 in. sieve 96.8 %
Cumulative percent passing the 1/2 in. sieve 75.6 %
Cumulative percent passing the 3/8 in. sieve 61.8 %
Cumulative percent passing the 1/4 in. sieve 100 %
Cumulative percent passing the #4 sieve 41 %
Cumulative percent passing the #8 sieve 31 %
Cumulative percent passing the #16 sieve 22.9 %
Cumulative percent passing the #30 sieve 15.3 %
Cumulative percent passing the #50 sieve 9.2 %
Cumulative percent passing the #100 sieve 6 %
Cumulative percent passing the #200 sieve 4.27 %

Test 2 of 2

DIME Test ID: 2019-07-25-11-2
Test Method: AASHTO T11-5: Standard Method of Test for Materials Finer Than 75-μm (No. 200) Sieve in Mineral Aggregates by Washing
Verified Date: 08/28/2019
Date Tested: 08/27/2019
Submitted By Organization: CT HQ - Sacramento Aggregate Testing Laboratory
Organization Address: 5900 Folsom Boulevard,
Organization City: Sacramento
Organization State: CA
Organization Zipcode: 95819
Organization Email: ryan.kester@dot.ca.gov
Organization Phone: (916) 227-7215
General Comments for this Test:
Test Result Compliance:
Additional Comments When Verified:
Which test procedure is being used Method A
Percent of sample passing the #200 sieve (by mass) 9.9 %