Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.
Project ID: 1000786 DEA: 081J4504 EFIS: 0818000043
QA Service Level: 1
DIST-CO-RTE-PM: 08-RIV-243-0.0/29.7
Work Description: HMA, THERMOPLASTIC TRAFFIC STRIPE, AND COLD PLANE AC PAVEMENT.
Location Description: RIVERSIDE COUNTY FROM ROUTE 74 AT MOUNTAIN CENTER TO ROUTE 10 IN BANNING
Contractor Name: ALL AMERICAN ASPHALT
Contractor Address: 400 EAST 6TH ST, CORONA, CA 92879
Resident Engineer: Md Rahman Structure Rep.: Unknown
DIME Sample ID: 2026-07-08-64
TL Number from the TL Form:
Sample Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Sample Organization Contact: 213-792-4794
Type of Sample: Acceptance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 07/08/2026
Date that the sample was received by the laboratory/organization performing the testing: 07/09/2026
The quantity of what the sample constitutes: 2 BOXES, LOAD #7, 132.66 TONS
A brief description of the sample: 3/4" WMA-A
From where was the sample collected: Supplier
Laboratory sample identification: 0401A-26
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: ALL AMERICAN ASPHALT -PERRIS
HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number: 2
Sublot number: 41
HMA Mix Number: 103819 PERRIS
Binder content (%): 4.8
Virgin binder PG: PG 64-16
Design binder PG: PG 64-16
Binder Supplier: SJR
RAP content (%): 15
WMA Additives: Yes
Antistrip type: 0.40 INGEVITY EVOSHIELD
DIME Test ID: 2026-07-08-64-1
Test Method: AASHTO T308-25: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 07/16/2026
Date Tested: 07/15/2026
Submitted By Organization: CT D08 - Fontana Southern Regional Laboratory
Organization Address: 13970 Victoria Street,
Organization City: Fontana
Organization State: CA
Organization Zipcode: 92336
Organization Email: jose.guzman@dot.ca.gov
Organization Phone: (213) 792-4797
General Comments for this Test: OVEN #2
RANGE 4.50-5.30
Test Result Compliance: complies
Additional Comments When Verified:
|
What temperature unit is used?
|
Celsius
|
|
Test procedure used?
|
Method A
|
|
Corrected Asphalt Binder Content
|
4.65 %
|
|
Mass of HMA Sample prior to ignition
|
2150.9 g
|
|
Mass Loss
|
110.9 g
|
|
Correction Factor (Percent by mass of HMA Specimen)
|
0.37 %
|
|
Moisture Content
|
no data0 %
|
|
Temperature Compensation Factor
|
0.13 %
|
|
Test Temperature
|
538 C
|
