Print Report | Back to Sample Detail

Sample Record for 2025-08-21-50

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 1001145 DEA: 033G4004 EFIS: 0324000124 QA Service Level: 1
DIST-CO-RTE-PM: 03-YOL-16-9.9/15
Work Description: PARTIAL DEPTH RECYCLING, AND RHMA-G.
Location Description: YOLO COUNTY AT AND NEAR GUINDA FROM 0.2 MILE EAST OF COUNTY ROAD 43 EAST INTERSECTION TO 0.1 MILE WEST OF COUNTY ROAD 68
Contractor Name: ALL-AMERICAN CONSTRUCTION, INC.
Contractor Address: Unknown
Resident Engineer: Luis Pompa Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2025-08-21-50
TL Number from the TL Form: C792129
Sample Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Sample Organization Contact: (530) 741-4238
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 08/21/2025
Date that the sample was received by the laboratory/organization performing the testing: 08/21/2025
The quantity of what the sample constitutes: 2 Boxes
A brief description of the sample: 1/2" RHMA-G
From where was the sample collected: Source
Laboratory sample identification: Daily 25-153
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Teichert Woodland

Material Information

HMA Type: RHMA-G
HMA Grading: 1/2 inch
Lot number: 1
Sublot number: 1
HMA Mix Number: 30640542500V
Binder content (%): 7.5
Virgin binder PG: PG 64-16
Design binder PG: PG 64-16
Binder Supplier: Valero
RAP content (%): 0
WMA Additives:
Antistrip type:
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2025-08-21-50-1
Test Method: AASHTO T209-22: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)
Verified Date: 09/03/2025
Date Tested: 08/25/2025
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test:
Test Result Compliance: not applicable
Additional Comments When Verified:
Number of Samples 1
What is the unit of measurement for theoretical density? SI Units
Mass Determination Air
Specific Gravity for Sample 1 2.423
Theoretical maximum density at 25°C (77°F) 2 kg/m^3

Test 2 of 2

DIME Test ID: 2025-08-21-50-2
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 09/03/2025
Date Tested: 08/25/2025
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: L1 OBC 7.5%
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of HMA Sample prior to ignition 1646.2 g
Corrected Asphalt Binder Content 7.46 %
Mass Loss 139.2 g
Correction Factor (Percent by mass of HMA Specimen) 1 %
Moisture Content no data0 %
Temperature Compensation Factor 0.02 %
Test Temperature 538 C