Print Report | Back to Sample Detail

Sample Record for 2025-05-02-63

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 1720 DEA: 040G0804 QA Service Level: 1
DIST-CO-RTE-PM: 04-SON,SOL-37-4.0/R6.1,R2/R7.4
Work Description: REPLACE ASPHALT CONCRETE SURFACING
Location Description: In Sonoma and Solano Counties in and near Vallejo from Tolay Creek Bridge to 0.2 mile east of Walnut Avenue Overcrossing
Contractor Name: MB Services
Contractor Address: PO Box 5697, Concord, Ca 94524
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2025-05-02-63
TL Number from the TL Form:
Sample Submitted By Organization: CT D04 - Concord Field Laboratory
Sample Organization Contact: (510) 714-7019
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 05/02/2025
Date that the sample was received by the laboratory/organization performing the testing: 05/22/2025
The quantity of what the sample constitutes: 100Tons
A brief description of the sample: 3/4 HMA
From where was the sample collected: Job Site
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Teichert Woodland

Material Information

HMA Type: RHMA-G
HMA Grading: 3/4 inch
Lot number: 5
Sublot number: 3
HMA Mix Number:
Binder content (%): 0.0
Virgin binder PG:
Design binder PG:
Binder Supplier:
RAP content (%):
WMA Additives:
Antistrip type:
Test results on following page(s): 1

Test Results

Test 1 of 1

DIME Test ID: 2025-05-02-63-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 07/15/2025
Date Tested: 05/23/2025
Submitted By Organization: CT D04 - Concord Field Laboratory
Organization Address: 2525 Stanwell Drive, Suite 100,
Organization City: Concord
Organization State: CA
Organization Zipcode: 94520
Organization Email: gurind.joshi@dot.ca.gov
Organization Phone: (510) 714-7019
General Comments for this Test:
Test Result Compliance: does not comply
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of HMA Sample prior to ignition 1643.1 g
Corrected Asphalt Binder Content 6.87 %
Mass Loss 116.5 g
Correction Factor (Percent by mass of HMA Specimen) 0.57 %
Moisture Content no data0 %
Temperature Compensation Factor 0.18 %
Test Temperature 538 C