Project Information

Project ID: 1000029 DEA: 101K4304 EFIS: 1021000096 QA Service Level: 1

DIST-CO-RTE-PM: 10-MER-165-16.5/26.8

Work Description: RHMA (GAP GRADED) AND FULL DEPTH RECYCLING- CEMENT.

Location Description: MERCED COUNTY NEAR LOS BANOS FROM 1.5 MILES NORTH OF WOLFSEN ROAD TO 0.1 MILE SOUTH OF ROUTE 140

Contractor Name: CAL VALLEY CONSTRUCTION, INC.

Contractor Address: Unknown

Resident Engineer: Jagga Dhami Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2025-06-04-93

TL Number from the TL Form: 0500017

Sample Submitted By Organization: CT D10 - District 10 Materials Laboratory

Sample Organization Contact: (209) 948-7567

Type of Sample: Quality Assurance

Type of Material: Hot Mix Asphalt

Sample Taken Date: 06/04/2025

Date that the sample was received by the laboratory/organization performing the testing: 06/04/2025

The quantity of what the sample constitutes: 4 boxes

A brief description of the sample: 1/2 RHMA-G

From where was the sample collected: Manufacturer

Laboratory sample identification: 25-H-113

Structure unique identifier:

Structure name:

The fabricator/manufacturer/facility name: Santa Fe Winton

Material Information

HMA Type: RHMA-G

HMA Grading: 1/2 inch

Lot number: 2

Sublot number: 2

HMA Mix Number: 25J07

Binder content (%):

Virgin binder PG:

Design binder PG:

Binder Supplier:

RAP content (%):

WMA Additives:

Antistrip type:

Test Results

Test 1 of 2

DIME Test ID: 2025-06-04-93-1

Test Method: AASHTO T209-22: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)

Verified Date: 06/18/2025

Date Tested: 06/09/2025

Submitted By Organization: CT D10 - District 10 Materials Laboratory

Organization Address: 1976 East Dr. Martin Luther King Jr. Boulevard,

Organization City: Stockton

Organization State: CA

Organization Zipcode: 95205

Organization Email: mandeep.dhesi@dot.ca.gov

Organization Phone: (209) 948-7567

General Comments for this Test:

Test Result Compliance: not applicable

Additional Comments When Verified:

Number of Samples	1
What is the unit of measurement for theoretical density?	US Units
Mass Determination	Water
Specific Gravity for Sample 1	2.387
Theoretical maximum density at 25°C (77°F)	148.5 lb/ft^3

Test 2 of 2

DIME Test ID: 2025-06-04-93-2

Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)