Print Report | Back to Sample Detail

Sample Record for 2024-07-23-160

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 994636 DEA: 022J9604 EFIS: 0221000153 QA Service Level: 1
DIST-CO-RTE-PM: 02-SIS-5-VAR
Work Description: PLACE POLYESTER CONCRETE OVERLAY, HMA (TYPE A), & REPLACE JOINT SEALS.
Location Description: SISKIYOU COUNTY AT VARIOUS LOCATIONS FROM OAK STREET UNDERCROSSING TO KLAMATH RIVER BRIDGE AND SEPARATION BRIDGE NO. 02-0134R
Contractor Name: DEES BURKE ENGINEERING CONSTRUCTORS, LLC
Contractor Address: 207 W State Street, Ontario, CA 91762
Resident Engineer: Nicole Mallory Structure Rep.: Carlos Paz

Sample Information

DIME Sample ID: 2024-07-23-160
TL Number from the TL Form: 858058
Sample Submitted By Organization: CT D02 - Redding Northern Regional Laboratory
Sample Organization Contact: (530) 225-3194
Type of Sample: Acceptance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 07/23/2024
Date that the sample was received by the laboratory/organization performing the testing: 12/03/2024
The quantity of what the sample constitutes: 1 Box HMA
A brief description of the sample: 3/4" HMA-A 20.8% RAP
From where was the sample collected: Manufacturer
Laboratory sample identification: D79781
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: JF Shea Construction, Fawndale Rock and Asphalt, Redding, CA

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number:
Sublot number:
HMA Mix Number:
Binder content (%):
Virgin binder PG:
Design binder PG:
Binder Supplier:
RAP content (%):
WMA Additives:
Antistrip type:
Test results on following page(s): 1

Test Results

Test 1 of 1

DIME Test ID: 2024-07-23-160-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 12/17/2024
Date Tested: 12/16/2024
Submitted By Organization: CT D02 - Redding Northern Regional Laboratory
Organization Address: 1657 Riverside Drive,
Organization City: Redding
Organization State: CA
Organization Zipcode: 96001
Organization Email: ward.jenkins@dot.ca.gov
Organization Phone: 530-225-3194
General Comments for this Test: Pb=4.71%
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of the specimen basket assembly 3113.9 g
Mass of the specimen and specimen basket assembly prior to ignition 5237.8 g
Mass of HMA Sample prior to ignition 2123.9 g
Corrected Asphalt Binder Content 4.72 %
Mass Loss 113.1 g
Mass of aggregate remaining after ignition 2010.8 g
Correction Factor (Percent by mass of HMA Specimen) 0.47 %
Moisture Content no data0 %
Temperature Compensation Factor 0.14 %
Test Temperature 538 C