Print Report | Back to Sample Detail

Sample Record for 2024-10-25-21

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 1000018 DEA: 042Q7604 EFIS: 0419000046 QA Service Level: 1
DIST-CO-RTE-PM: 04-ALA-238,680-0.7/0.8,M0.1
Work Description: RECTANGULAR RAPID FLASHING BEACON SYSTEMS, HMA, CURB RAMP AND SW.
Location Description: ALAMEDA COUNTY IN FREMONT ON ROUTE 680 AT OFF-RAMP TO SCOTT CREEK ROAD AND ON ROUTE 238 AT MISSION BRIDGE COURT
Contractor Name: GHILOTTI BROS, INC.
Contractor Address: 525 Jacoby Street, San Rafael, CA 94901
Resident Engineer: Reza Kamkar Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2024-10-25-21
TL Number from the TL Form: C772355
Sample Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Sample Organization Contact: (510) 224-6127
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 10/25/2024
Date that the sample was received by the laboratory/organization performing the testing: 10/28/2024
The quantity of what the sample constitutes: 750 Tons
A brief description of the sample: 3/4"HMA w/25% RAP
From where was the sample collected: Source
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Vulcan Pleasanton

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number: 1
Sublot number: 1
HMA Mix Number: MD6742 WM
Binder content (%):
Virgin binder PG:
Design binder PG:
Binder Supplier:
RAP content (%):
WMA Additives:
Antistrip type:
Test results on following page(s): 1

Test Results

Test 1 of 1

DIME Test ID: 2024-10-25-21-1
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 11/01/2024
Date Tested: 10/31/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Burn #1
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of the specimen basket assembly 2896.1 g
Mass of the specimen and specimen basket assembly prior to ignition 4916.7 g
Mass of HMA Sample prior to ignition 2020.6 g
Corrected Asphalt Binder Content 4.95 %
Mass Loss 127.9 g
Mass of aggregate remaining after ignition 1892.7 g
Correction Factor (Percent by mass of HMA Specimen) 1.23 %
Moisture Content no data0 %
Temperature Compensation Factor 0.15 %
Test Temperature 482 C