Print Report | Back to Sample Detail

Sample Record for 2024-10-19-4

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 993825 DEA: 040Q30U4 EFIS: 0420000235 COOP: 042830A3,042830A4 QA Service Level: 1
DIST-CO-RTE-PM: 04-ALA,CC-680-R11.0/R21.9,R0.0/R0.9
Work Description: PRECAST CONC PVMT, ELECTRONIC TOLL SYSTEM, JPCP, CB & STRUCTURAL CONC
Location Description: ALAMEDA AND CONTRA COSTA COUNTIES AT SUNOL AND IN SAN RAMON BETWEEN 0.4 MILE SOUTH OF CALAVERAS ROAD UNDERCROSSING TO 0.9 MILE NORTH OF ALCOSTA BOULEVARD OVERCROSSING
Contractor Name: BAY CITIES PAVING & GRADING (Jason Ochoa)
Contractor Address: 1450 CIVIC CT, BLDG B #400, CONCORD, CA 94520
Resident Engineer: Yannaing Tun Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2024-10-19-4
TL Number from the TL Form: C101924
Sample Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Sample Organization Contact: (510) 224-6127
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 10/19/2024
Date that the sample was received by the laboratory/organization performing the testing: 10/19/2024
The quantity of what the sample constitutes: 750 Tons
A brief description of the sample: HMA-SP Type A w/25% RAP
From where was the sample collected: Source
Laboratory sample identification:
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: Vulcan Pleasanton

Material Information

HMA Type: Type A HMA
HMA Grading: 3/4 inch
Lot number: 7
Sublot number: 7
HMA Mix Number: 220304
Binder content (%):
Virgin binder PG:
Design binder PG:
Binder Supplier:
RAP content (%):
WMA Additives:
Antistrip type:
Test results on following page(s): 10

Test Results

Test 1 of 10

DIME Test ID: 2024-10-19-4-1
Test Method: AASHTO T209-22: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)
Verified Date: 10/23/2024
Date Tested: 10/19/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 7
Test Result Compliance: not applicable
Additional Comments When Verified:
Number of Samples 1
What is the unit of measurement for theoretical density? SI Units
Mass Determination Air
Method Performed Mechanical Agitation - Method A
Mass of container filled with water 1 7335.6 grams
Mass of oven-dry sample in air for Sample 1 2522.5 grams
Mass of container filled with the sample and water for Sample 1 8855.8 grams
Temperature of Water no data0 °F
Specific Gravity for Sample 1 2.517
Theoretical maximum density at 25°C (77°F) 2510 kg/m^3

Test 2 of 10

DIME Test ID: 2024-10-19-4-2
Test Method: AASHTO T275-07r12: Standard Method of Test for Bulk Specific Gravity (Gmb) of Compacted Asphalt Mixtures Using Paraffin-Coated Specimens (Bulk Specific Gravity)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 7
Test Result Compliance: not applicable
Additional Comments When Verified:
Bulk Specific Gravity 2.398
Bulk Specific Gravity 2 2.341
Bulk Specific Gravity 3 2.338
Average Bulk Specific Gravity 2.359

Test 3 of 10

DIME Test ID: 2024-10-19-4-3
Test Method: AASHTO T269-14: Standard Method of Test for Percent Air Voids in Compacted Dense and Open Asphalt Mixtures (Air Void)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 7
Test Result Compliance: complies
Additional Comments When Verified:
Percent Air Voids 4.7 %
Percent Air Voids 2 7 %
Percent Air Voids 3 7.1 %
Average Percent Air Voids 6.3 %

Test 4 of 10

DIME Test ID: 2024-10-19-4-4
Test Method: AASHTO T275-07r12: Standard Method of Test for Bulk Specific Gravity (Gmb) of Compacted Asphalt Mixtures Using Paraffin-Coated Specimens (Bulk Specific Gravity)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 8
Test Result Compliance: not applicable
Additional Comments When Verified:
Bulk Specific Gravity 2.364
Bulk Specific Gravity 2 2.389
Bulk Specific Gravity 3 2.393
Average Bulk Specific Gravity 2.382

Test 5 of 10

DIME Test ID: 2024-10-19-4-5
Test Method: AASHTO T269-14: Standard Method of Test for Percent Air Voids in Compacted Dense and Open Asphalt Mixtures (Air Void)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 8
Test Result Compliance: complies
Additional Comments When Verified:
Percent Air Voids 6.1 %
Percent Air Voids 2 5.1 %
Percent Air Voids 3 4.9 %
Average Percent Air Voids 5.4 %

Test 6 of 10

DIME Test ID: 2024-10-19-4-6
Test Method: AASHTO T275-07r12: Standard Method of Test for Bulk Specific Gravity (Gmb) of Compacted Asphalt Mixtures Using Paraffin-Coated Specimens (Bulk Specific Gravity)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 9
Test Result Compliance: not applicable
Additional Comments When Verified:
Bulk Specific Gravity 2.386
Bulk Specific Gravity 2 2.412
Bulk Specific Gravity 3 2.416
Average Bulk Specific Gravity 2.405

Test 7 of 10

DIME Test ID: 2024-10-19-4-7
Test Method: AASHTO T269-14: Standard Method of Test for Percent Air Voids in Compacted Dense and Open Asphalt Mixtures (Air Void)
Verified Date: 10/23/2024
Date Tested: 10/22/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 9
Test Result Compliance: complies
Additional Comments When Verified:
Percent Air Voids 5.2 %
Percent Air Voids 2 4.2 %
Percent Air Voids 3 4 %
Average Percent Air Voids 4.5 %

Test 8 of 10

DIME Test ID: 2024-10-19-4-8
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 10/31/2024
Date Tested: 10/19/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 7
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of the specimen basket assembly 2898.5 g
Mass of the specimen and specimen basket assembly prior to ignition 4957.1 g
Mass of HMA Sample prior to ignition 2058.6 g
Corrected Asphalt Binder Content 4.38 %
Mass Loss 117.2 g
Mass of aggregate remaining after ignition 1941.4 g
Correction Factor (Percent by mass of HMA Specimen) 1.19 %
Moisture Content no data0 %
Temperature Compensation Factor 0.12 %
Test Temperature 482 C

Test 9 of 10

DIME Test ID: 2024-10-19-4-9
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 10/31/2024
Date Tested: 10/19/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 8
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of the specimen basket assembly 3550 g
Mass of the specimen and specimen basket assembly prior to ignition 5587 g
Mass of HMA Sample prior to ignition 2037 g
Corrected Asphalt Binder Content 4.83 %
Mass Loss 124.9 g
Mass of aggregate remaining after ignition 1912.1 g
Correction Factor (Percent by mass of HMA Specimen) 1.19 %
Moisture Content no data0 %
Temperature Compensation Factor 0.11 %
Test Temperature 482 C

Test 10 of 10

DIME Test ID: 2024-10-19-4-10
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 10/31/2024
Date Tested: 10/19/2024
Submitted By Organization: CT D04 - Pleasanton Field Laboratory
Organization Address: 5675 B Gibratar Drive,
Organization City: Pleasanton
Organization State: CA
Organization Zipcode: 94588
Organization Email: dennis.yeung@dot.ca.gov
Organization Phone: (510) 224-6127
General Comments for this Test: Lot 7 Sublot 9
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of the specimen basket assembly 2919.4 g
Mass of the specimen and specimen basket assembly prior to ignition 4978 g
Mass of HMA Sample prior to ignition 2058.6 g
Corrected Asphalt Binder Content 4.75 %
Mass Loss 125 g
Mass of aggregate remaining after ignition 1933.6 g
Correction Factor (Percent by mass of HMA Specimen) 1.19 %
Moisture Content no data0 %
Temperature Compensation Factor 0.13 %
Test Temperature 482 C