Print Report | Back to Sample Detail

Sample Record for 2024-09-11-36

Note: Fields with no data or with a value of "Unknown" will not be displayed on the print out.

Project Information

Project ID: 1000206 DEA: 033G2704 EFIS: 0324000079 QA Service Level: 1
DIST-CO-RTE-PM: 03-SUT-99-8.3/14.1
Work Description: REPLACE PAVEMENT.
Location Description: SUTTER COUNTY ON ROUTE 99 NEAR NICOLAUS FROM 0.3 MILE NORTH OF ROUTE 70 JUNCTION TO 0.6 MILE SOUTH OF LAUREL AVENUE
Contractor Name: GEORGE REED, INC.
Contractor Address: Unknown
Resident Engineer: Unknown Structure Rep.: Unknown

Sample Information

DIME Sample ID: 2024-09-11-36
TL Number from the TL Form: C803818
Sample Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Sample Organization Contact: (530) 741-4238
Type of Sample: Quality Assurance
Type of Material: Hot Mix Asphalt
Sample Taken Date: 09/11/2024
Date that the sample was received by the laboratory/organization performing the testing: 09/12/2024
The quantity of what the sample constitutes: 1/2" RHMA-G
A brief description of the sample: 2 Boxes
From where was the sample collected: Source
Laboratory sample identification: Daily 24-187
Structure unique identifier:
Structure name:
The fabricator/manufacturer/facility name: George Reed Elkhorn Blvd

Material Information

HMA Type: RHMA-G
HMA Grading: 1/2 inch
Lot number: 1
Sublot number: 4
HMA Mix Number:
Binder content (%):
Virgin binder PG:
Design binder PG:
Binder Supplier:
RAP content (%):
WMA Additives:
Antistrip type:
Test results on following page(s): 2

Test Results

Test 1 of 2

DIME Test ID: 2024-09-11-36-1
Test Method: AASHTO T209-22: Standard Method of Test for Theoretical Maximum Specific Gravity (Gmm) and Density of Asphalt Mixtures (Maximum Specific Gravity)
Verified Date: 09/13/2024
Date Tested: 09/12/2024
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test:
Test Result Compliance: not applicable
Additional Comments When Verified:
Number of Samples 1
What is the unit of measurement for theoretical density? SI Units
Mass Determination Air
Specific Gravity for Sample 1 2.446
Theoretical maximum density at 25°C (77°F) 2 kg/m^3

Test 2 of 2

DIME Test ID: 2024-09-11-36-2
Test Method: AASHTO T308-10: Standard Method of Test for Determining the Asphalt Binder Content of Hot Mix Asphalt (HMA) by the Ignition Method (Method A) (Asphalt Binder Content)
Verified Date: 09/13/2024
Date Tested: 09/12/2024
Submitted By Organization: CT D03 - Olivehurst Northern Regional Laboratory
Organization Address: 5330 Arboga Road,
Organization City: Olivehurst
Organization State: CA
Organization Zipcode: 95961
Organization Email: jeff.herbert@dot.ca.gov
Organization Phone: (530) 741-4238
General Comments for this Test: R1 OBC 7.8
Test Result Compliance: complies
Additional Comments When Verified:
What temperature unit is used? Celsius
Test procedure used? Method A
Mass of HMA Sample prior to ignition 1710.8 g
Corrected Asphalt Binder Content 8.22 %
Mass Loss 148.2 g
Correction Factor (Percent by mass of HMA Specimen) 0.44 %
Moisture Content no data0 %
Temperature Compensation Factor 0.02 %
Test Temperature 538 C